Trouble-shooting
In the event of a fault, please contact your dealer or the Truma-
Service (see page 37).
Before calling customer service, please check the following:
1. Are the batteries in the remote handset in good condition?
2. Is the caravan battery in good condition and fully charged?
Do not use the Mover if the battery voltage is below 10.2 V DC.
Changing the batteries in the remote handset
Please be sure to use leak proof
micro-batteries only, type LR 03,
AAA, AM 4, MN 2400 (1.5 V).
When fitting new batteries en-
sure the polarity is correct!
Dead and used batteries
may leak and damage the
remote handset. Remove the
batteries if the handset is not go-
ing to be used for an extended
period.
No claims under guarantee will be considered for dam-
age caused by leaking batteries.
Before throwing away a defective handset, it is essential that
the batteries are removed and disposed of in proper manner.
Aligning the Electronic Control Unit and the
Remote Handset
After replacing a electronic control unit or a remote handset
the individuals must be aligned by the following procedure.
1. Ensure the Mover is installed in accordance with the installation
instructions. Ensure the caravan battery is connected, in good
condition and supplies 12 V, DC to the electronic control unit.
2. Press the reset button (h) until the light (i) flashes.
3. Press the red button (a) on the handset twice within one
second. This will align the handset and installed control unit.
2
Maintenance
The drive units should be kept reasonably clean of road debris.
Clean the area with a hose pipe to release mud, etc. along with
cleaning the caravan. Make sure no large stones, wood
branches, etc. are trapped in the mechanism. There is no more
care than the above required on the drive units. The controllers
require no maintenance. Keep the handset in a dry place.
You or your Caravan Dealer can check maintenance on the
Mover very simply, along with the annual service of the cara-
van. If in doubt, please contact the Truma-Services (page 37).
1. Upon an annual basis (or before storing the caravan for the
winter) we recommend that you clean the unit as described
above, dry off and lightly spray the drive units and mecha-
nisms with WD40 or a similar silicon lubricant/water repellent.
Keep the spray off the rollers and tyres! Apply and release
the drive units a few times to work the spray into all the joints.
Do not store the caravan with the drive rollers engaged.
2. After a long period of inactivity, repeat step 1 and charge the
caravan battery before starting up.
3. The motors and gearboxes are sealed for life.
Checks
1. Always ask your dealer to check the installation each year
when the caravan is serviced.
2. Check for damage to the installation, wiring and connec-
tions. The drive units must be able to move freely and automati-
cally move away from the tyres when released. If they do not,
examine the unit for debris or corrosion at the pivot points and
adjust if necessary. Free all pivots as required, oil or spray with
WD40 to ensure full and correct movement.
3. After the annual maintenance, check that all motors respond
correctly to the handset buttons.
General instructions
The manufacturer accepts no responsibility for consequential
damage caused by incorrect installation or operation.
The driver rollers are guaranteed against manufacturing faults
for 24 months. However, the guarantee does not cover normal
wear or damage caused by sharp-edged objects such as
stones jammed in the tyres.
For the use of the Mover we recommend traction or lighting
batteries (min. 88 AH), also solar and gel batteries are suitable.
Normal starter batteries are not suitable. To charge the battery
we recommend chargers with IUoU charging characteristic.
These avoid overcharging the battery.
There are limits to the Mover’s capabilities. It has been de-
signed to climb slopes up to 1:4 reliably and safely on reason-
able surfaces. Always consider with care and consideration the
action you are going to take by considering the effort required
if you were attempting the manoeuvre using your tow car.
The Mover cannot overcome obstacles more than approx.
2.0 cm in height without assistance (please use wood wedges).
Due to the nature of a radio signal, it can get corrupted by ex-
ternal terrain or objects. So there may be small areas around
the caravan where the quality of reception reduces, hence the
Mover may stop momentarily.
