753343
7
Verklein
Vergroot
Pagina terug
1/13
Pagina verder
EN 7
glue gun PGGS 10-230V
Technical data
Parameter Value
Model PGGS 10-230V
Mains connection 1/N/PE ~ 220–240V/ 50Hz
Power input 25W
(500W at start-up)
Ambient temperature working 5°C to 50°C
Melting point 200°C
Glue stick
Diameter
Length
11mm
150mm
Heating time approx. 5 min
Cable length 2 m
Weight 0.3 kg
Transport and storage
Note
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
For transporting the device, use the transport case included in
the scope of delivery in order to protect the device from external
influences.
Before transporting the device, observe the following:
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Allow the device to cool down.
Storage
Before storing the device, observe the following:
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Allow the device to cool down.
Clean the device as described in the Maintenance chapter.
For storing the device, use the transport case included in
the scope of delivery in order to protect the device from
external influences.
When the device is not being used, observe the following
storage conditions:
dry and protected from frost and heat
ambient temperature below 45°C
protected from dust and direct sunlight inside the transport
case
Start-up
Unpacking the device
Take the transport case out of the packaging.
Warning of electrical voltage
Electric shock from insufficient insulation.
Check the device for damages and proper functioning
before each use.
If you notice damages, no longer use the device.
Do not use the device when the device or your hands
are damp or wet!
Check the scope of delivery for completeness and look for
damages.
Warning
Risk of suffocation!
Do not leave the packaging lying around. Children may
use it as a dangerous toy.
Dispose of the packaging material according to the
national regulations.
Mounting the wire stand
Wear safety glasses
The wire stand may jump away and cause eye injury
while being mounted. Wear suitable eye protection.
The wire stand must be attached to the device prior to initial
start-up.
1. Pull the ends of the wire stand(6) slightly apart and slide
them into the fixture on the left and right side of the
device.
6
2. You can remove the wire stand by pulling it out of the
fixture.
Inserting a glue stick
1. Push a glue stick into the feed channel(1).
Connecting the power cable
1. Insert the mains plug into a properly secured mains
socket.
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Trotec PGGS 10-230V bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Trotec PGGS 10-230V in de taal/talen: Engels als bijlage per email.

De handleiding is 1,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Trotec PGGS 10-230V

Trotec PGGS 10-230V Gebruiksaanwijzing - Nederlands - 13 pagina's

Trotec PGGS 10-230V Gebruiksaanwijzing - Deutsch - 13 pagina's

Trotec PGGS 10-230V Gebruiksaanwijzing - Français - 13 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info