INSTALLING YOUR WINE CABINET
-When you receive your cabinet, make sure when you unpack it there is no defect in its external
appearance (from shocks, deformation, etc.).
-Open the door and check to see that the inside is complete (walls, shelves hinges, control
panel, etc.)
-If you wish to install your cabinet under a worktop, you will need to remove the top plate which
is fixed from underneath by two front screws in the hinges and two screws behind in the angle
brackets, Keep the two front screws if you wish to encase the unit under a worktop so as to fix
it to existing worktop (see diagrams page 4)
-Now carry the cabinet to where you want to install it. Make sure the place selected is:
-away from any source of heat
-not too damp(laundry room, utility room, bathroom, etc.)
-on a stable level surface
-equipped with a power point(standard socket, rated voltage, 16A, connected to earth)
-Make sure the On/Off switch located on the right of the control panel is in the off position.
-Take out the mains lead and connect it as shown in section 3. Check the power point supply
(fuses in, fuse amperage, circuit breaker working, You can if you wish use another appliance to
check the power supply.)
-Adjust the four feet underneath the cabinet (screwing them up or unscrewing them) so that
your cabinet is level (it is advisable to use a spirit level).
-Slide the cabinet into its final position, leaving a space of between 2 and 6 cm between the
wall and the rear wall of the cabinet, for installation under a worktop (Model 103), fix the cabinet
to the worktop using two screws in the top hinges (see diagram below).
-Do not obstruct the front ventilation grille.
-Make a ventilation hole (flush-mounted grille) in the worktop (see diagram 4 below)
-Remove the protective materials from the inside of the cabinet.
-Remove the protective paper form the charcoal filter that you will find in the accessories pack,
Form inside the cabinet, position the filter in the round box located in the top back of the
cabinet.
-Arrange the shelves to suit your convenience (see section 6.)
-Wait 48 hours before switching the cabinet on so as to allow the fluids to settle.
NB: If ever you need to move the cabinet, do not tilt it at an angle of more that 45°,and
always on the side where the lead comes out.
The appliance must be positioned so that the plug is accessible.
3
