Handleiding Tristar ST 8233 (pagina 7 van 57) (Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools, Turks, Deens, Zweeds, Noors, Fins)

457528

Verklein

Vergroot

Pagina terug

1/57

Pagina verder

Selecting the steam.

The quantity of steam is regulated by the steam selector (no.11).

Move the steam selector to a position between minimum and maximum depending on the

quantity of steam required and the temperature selected see fig. 1.

Warning: the iron gives off steam continuously only if you hold the iron horizontally. You can

stop the continuous steam by placing the iron in a vertical position or by moving the steam

selector to . As indicated on the thermostat knob (no. 5), you can only use steam at the

highest temperatures. If the selected temperature is too low, water may drip out of the plate.

Selecting steam when ironing vertically.

Press the shot-steam button (no.10) to generate a powerful burst of steam that can penetrate

the fabrics and smooth the most difficult and tough creases. Wait for a few seconds before

pressing again see fig. 4.

By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung

garments, etc.) see fig. 5.

Warning: the shot-steam function can only be used at high temperatures.

Spray Function

Make sure that there is water in the reservoir. Press the spray button (no. 9) slowly (for a

dense spray) or quickly (for a vaporized spray) see fig. 6.

Warning: for delicate fabrics, we recommend moistening the fabric beforehand using the spray

function (no. 9), or putting a damp cloth between the iron and the fabric. To avoid staining, do

not use the spray on silk or synthetic fabrics.

Cleaning

Please note: before cleaning the iron in any way, make sure that the appliance plug is not

connected to the socket.

Any paste or other remains left on the plate can be removed using a damp cloth or an

unabrasive liquid detergent.

Avoid scratching the plate with steel wool or metallic objects.

The plastic parts can be cleaned with a damp cloth then wiped over with a dry cloth.

Self-cleaning

The self-cleaning feature cleans inside the plate, removing impurities. We recommend to do

this every 10-15 days. Directions: Fill the reservoir up to the maximum level indicated and set

the steam selector (no. 11) to . Set the thermostat knob (no. 5) to the maximum

temperature.

Pull the plug out of the socket and hold the iron horizontally over the sink. Hold the selfclean

button (no. 4) setting until all the boiling water, steam, impurities come out see fig. 7.

When the soleplate has cooled down, you can clean it with a damp cloth.

How yo put it away

Disconnect the plug from the socket and leave the iron to cool down completely.

Empty the reservoir by turning the iron upside down and gently shaking it. Roll up the power

cord on the rewinder see fig. 8. Always put the iron away in a vertical position.

Advice for good ironing

- We recommend using the lowest temperatures with fabrics that have unusual finishes

(sequins, embroidery, flush, etc.). If the fabric is mixed (e.g. 40% cotton 60% synthetics),

set the thermostat to the temperature of the fibre requiring the lower temperature.

- If you don’t know the composition of the fabric, determine the suitable temperature by

testing on a hidden corner of the garment. Start with a low temperature and increase it

gradually until it reaches the ideal temperature.Never iron areas with traces of perspiration

or other marks: the heat of the plate fixes the stains on the fabric, making them

irremovable.The result is more effective if you use a dry iron at a moderate temperature;

excess heat scorches it with the risk of forming a yellow mark.

- To avoid marking silk, woolen or synthetic garments getting shiny, iron them inside out.

- To avoid marking velvet garments shiny, iron in one direction (following the fibre) and do

not press down on the iron.

- The heavier the washing machine is loaded, the more garments come out creased. This

also happens when the spin drying revolutions are very high.

- Many fabrics are easier to iron if they are not completely dry. For example, silk should

always be ironed damp.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Tristar ST 8233 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info