21
ironing
until the plate temperature control light comes on again.
Selecting the steam.
The quantity of steam is regulated by the steam selector (3).
- Move the steam selector to a position between minimum and maximum depending on the quantity of steam
required and
the temperature selected
[Fig. 1]
.
Warning:
the iron gives off steam continuously only if you hold the iron horizontally. You can stop the continuous steam
by placingthe iron in a vertical position or by moving the steam selector to “0”. As indicated on the thermostat knob (11)
and in the initial table, you can only use steam at the highest temperatures. If the selected temperature is too low, water
may drip onto the plate.
Selecting Shot-steam and steam when ironing vertically.
Press the shot-steam button (5) to generate a powerful burst of steam that can penetrate the fabrics and smooth the
most difficult and tough creases. Wait for a few seconds before pressing again
[Fig. 4]
.
By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung garments, etc.)
[Fig. 5].
Warning:
the shot-steam function can only be used at high temperatures. Stop the emission when the plate
temperature control light (9) comes on, than start ironing again only after the light has gone off.
DRY IRONING
To iron without steam, follow the instructions in section “steam ironing”, leaving the steam selector (3) on position “0”.
Spray Function
Make sure that there is water in the reservoir. Press the spray button (4) slowly (for a dense spray) or quickly
(for a vaporized spray)
[Fig. 6]
.
Warning:
for delicate fabrics, we recommend moistening the fabric beforehand using the spray function (4), or
putting a damp cloth between the iron and the fabric. To avoid staining, do not use the spray on silk or synthetic fabrics.
CLEANING
Please note: before cleaning the iron in any way, make sure that the appliance plug is not connected to the
socket.
Any deposits, starch residue or size left on the plate can be removed using a damp cloth or an unabrasive liquid
detergent.
Avoid scratching the plate with steel wool or metallic objects.
The plastic parts can be cleaned with a damp cloth then wiped over with a dry cloth.
SELF-CLEANING
The self-cleaning feature cleans inside the plate, removing impurities. We recommend using it every 10-15days.
Directions:
-Fill the reservoir up to the maximum level indicated and set the steam selector (3) to “0”
-Set the thermostat knob (11) to the maximum temperature and wait for the light (6) to turn off.
-Pull the plug out of the socket and hold the iron horizontally over the sink.
-Hold the cleanout button (12) setting until all the boiling water, steam, impurities come out
[Fig. 7]
.
-When the soleplate has cooled down, you can clean it with a damp cloth.
HOW TO PUT IT AWAY
- Disconnect the plug of the iron from the socket.
- Empty the reservoir by turning the iron upside down and gently shaking it.
- Leave the iron to cool down completely.
- Roll up the power cord with the rewinder
[Fig. 8]
.
- Always put the iron away in a vertical position.
ADVICE FOR GOOD IRONING
