10 EYL900-01
EN
Warranty
- Read the installation instructions carefully. Wrong installation, use or repair voided warranty. If recovery is needed, consult a
dealer.
General remarks
- Check if the supplied EasyLink suits the type, length, and the projection of the canopy. Check that the height of the tent
matches the mounting height of the caravan rail (height between the ground and the rail where the tent slides in).
- Make sure the vehicle is leveled.
- The sun can affect colors depending on usage.
Steps 1 to 7
1. Open the awning maximal.
2. Slide the tendon of the tent trough the rail that is located under your awning. Use the pull-tab. For easy installation, do this
with two people.
3. Slide the pieces with the eye in the lead rail of the awning and the pieces with a hook on the straps of the tent. Bind the
velcro on the roof around the tension rafter if you want to hang a lamp inside the tent.
4. Hook the tent to the front profile using the mounting pieces. Use both hands to clamp the tent. * If the support leg of the
awning is standing on the windslip, make sure you add proper support under it to prevent damaging the tent.
5. Put the tent leveled, but the awning under a slight angle for proper water drainage.
6. Fix the EasyLink with pegs and pins, but always with closed zippers. Start at the back of the vehicle and hook the strap to the
vehicle. [A] Proceed with the front and tension the 2 straps with rings on the corners. Make sure all walls are straight and well
tensioned. [B] Finally use proper pegs depending on the type of soil to fix the tent to the ground. [C]
7. Assemble the windslip through the caravan rail. Attach the wheel cover using the screws ( for walls with wood base ) or
rivets ( for walls with foam base ). Close the holes with silicone to avoid water infiltration.
Safety
- Put one side of the awning lower so that when it rains the water can drain.
- When wind reaches 6 Bft. please store the tent and close the awning.
- Don’t place heat sources near the walls or the roof.
- Avoid covering the refrigerator grille with the tent.
- Use a Strap kit and a tension rafter on the awning before tightening the tent completely.
Maintenance
- Make sure that before installing the tent, the connections to the vehicle are sufficiently clean. Sand, dust or dirt could cause
damage to your vehicle. When you stay for a long period, clean the tent a few times.
- Ensure that there are no hard objects on the windows of the tent during folding. This is to prevent impressions on the window.
- Let the tent dry thoroughly before storing.
- Use pure water or a dry brush to clean the tent.
- Condensation inside the tent is normal. Ventilate the tent adequately.
