Page 3
We hope you really enjoy the warmth of your new gas fire Read these instructions carefully before
installing and using the gas fire. Keep these instructions in a safe place. Always provide the following
information if the gas fire breaks down: model and serial number, which can be found on the unit. Your
purchase invoice is your proof of warranty.
1. General
The entire unit is delivered to you with your choice of mantle and/or accessories. See the installation instructions
for the relevant mantle and/or accessories that are packaged separately from the unit. Check the unit immediately
after delivery to confirm that it has not been damaged during transport. If it is damaged in any way, please
inform your supplier immediately and provide as many details as possible. Your fire has been finished with
special paint that can withstand extremely high temperatures. Allow the fire to burn at the highest setting and
ventilate the room thoroughly during the first hours of use. As the paint is cured, this will cause a non-hazardous smell and/
or some smoke to be emitted
. Any deposit on the heat-resistant glass should be removed immediately using a
fireplace cleaner suitable for heat-resistant glass.
Attention
The unit must be installed, connected and checked by a qualified fitter based on national, regional, and local
standards and regulations. The fitter must inspect the unit for tightness in relation to gas and combustion
products and correct operation of the different components and functions. The flue tube system and the outlets in
the outer wall or roof face must also meet the requirements of the applicable regulations. The unit falls in the
closed unit category, in a set-up location without a fan and with a chimney loss that is greater than 17 % (non-
condensing).
Warning
Gas fires become hot when in use. Therefore care should be taken, for example, by keeping children and those
requiring help away from the immediate vicinity of burning fires. Gas fires must not be placed on or against
flammable materials (curtains, etc.).
1.1 Package contents:
1 x Base unit
1 x Wood mixset
1 x Operating and installation instructions
1 x Remote control
1 x Restriction plate and Restriction plate ø 65
1 x Radiation plate
1 x 9 volt battery
4 x AA 1.5V batteries
1 x 45º Bend Ø100/150
