636745
15
Verklein
Vergroot
Pagina terug
1/21
Pagina verder
Side 15
Assembly
1. Loosen the 3 screws (A). Push the lower blower tube into the upper blower tube.
Pay attention to that the edges (E) is fitted properly
Tighten the 3 screws (A) again.
2. Loosen the 2 screws (B) and take them out.
Loosen the 2 screws (C) and the 3 screws (D).
Insert the blower tube into the engine unit, fit the screws (B) again and tighten all
the screws (B+C+D)
3. Mount the dust bag under the engine unit with the air tube inside.
4. Fix the strap to the strap buckle.
Fuel and Oil
- This product is equipped with a two-stroke engine.
- Always use unleaded fuel (octane 95).
- Never use already mixed gasoline/oil from gas stations that is normally used for
mopeds, motorcycles i.e.
- Always follow the directions from the supplier of the oil regarding the mix of oil and
gasoline.
- Use a clean and approved fuel can for mixing the oil with the gasoline.
- Use an approved two-stroke oil for air cooled engines (e.g. chain saws, trimmers).
(Do not use oil for outboard motors or car oil). Mix only in small quantities.
- Texas recommends Texas Motex 2TX mixed 40:1 / 2.5%.
Mix 0,1 l Motex 2TX oil with 4 l unleaded gasoline. If another oil is used a 4%
mixture is required. But you should always follow the directions given by the
manufacturer of the oil.
- Mix the oil and the gasoline thoroughly and shake the mix before using.
- Never use a mix of gasoline and oil that is more than 90 days old as this may lead
to problems starting the engine. Never store the same mix in the tank for more than
30 days.
- When storing the machine for more than 30 days you should empty the tank.
Filling of gasoline – Smoking prohibited!
1. Unscrew the fuel cap. Place it on a clean surface.
2. Carefully pour the oil mixed fuel into the tank. Beware of spilling.
3. Screw the cap on tightly. Wipe away any spilled fuel.
4. It is normal that the engine smokes the first time it is used.
Notice! Always turn off the engine before fuelling. Never add fuel into a machine that is
running or when the engine is hot. (Cooling time at least 5 minutes). Move more than 3
meters away from the place where you add fuel on the engine before starting it.
15

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Texas GBV 300 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Texas GBV 300 in de taal/talen: Engels, Deens als bijlage per email.

De handleiding is 1,14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info