INSTALLATION
TECHNICAL INFORMATION FOR THE INSTALLER
Installation, adjustments of controls and maintenance
must only be carried out by a qualified engineer.
Incorrect installation may cause damage to persons,
animals or property for which the Manufacturer shall
not be considered responsible.
During the life of the system, the automatic safety or
regulating devices on the appliance may only be
modified by the manufacturer or by his duly authorized
dealer.
4) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children's reach since they could become
potential sources of danger.
The measurements of the opening made in the top of the
modular cabinet and into which the hot plate will be
installed are indicated in either fig. 9. Always comply with
the measurements given for the hole into which the
appliance will be recessed (see fig. 9 and 10).
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
5) FIXING THE HOT PLATE
The hot plate has a special seal which prevents liquid
from infiltrating into the cabinet. Strictly comply with
the following instructions in order to correctly apply
this seal:
- detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hot plate and correctly position seal "E"
(fig. 11) under the edge of the hot plate itself, so that
the outer side of the seal perfectly matches the
outer perimetral edge of the hot plate. The ends of
the strips must fit together without overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove the
strip of protective paper from the seal and set the
plate into the hole made in the cabinet.
- Fix the hob with the proper brackets “S” and fit the
prominent part into the porthole “H” on the bottom;
turn the screw “F” until the bracket “S” stick on the
top (fig. 12).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the working,
is necessary to put a wooden insert, fixed by
screws, at a minimum distance of 60 mm from the
top (see fig. 9).
FIG. 11 FIG. 12
FIG. 9 FIG. 10
COMPLY WITH THE DIMENSIONS (mm
26
A B C D E
3F + 1P (60) 553 473 63.5 63.5 100 min.
3F - 4F (60) 553 473 63.5 63.5 100 min.
5F (70) 553 473 63.5 63.5 175 min.
5F (90) 833 475 62.5 62.5 73.5 min.
