572940
26
Verklein
Vergroot
Pagina terug
1/69
Pagina verder
26
“Auto off” System
For your safety, the generator is equipped with an “auto off” system which switches the
generator to standby mode if it is not used for 8 minutes or if you forget to turn it off.
A red light blinks on the control panel to indicate that the appliance is in standby mode -
fig.15.
To reactivate the generator:
- Press the “Restart” button.
- Wait for the light on the “steam ready” button to stop blinking before your start ironing
again.
If the steam trigger is not pressed for at least 8 minutes, the “auto off” system will cut off
your generator for your safety.
Storing your generator
Place the iron on the iron rest of the generator.
Press the illuminated on/off switch and unplug the generator.
Raise the retaining hoop over the iron until it locks into place (audible click)
fig.2. Your
iron is then safely retained on its base.
Store the steam cord in its slide storage place. Take it, fold it in two so as to make a loop.
Put the end of this loop in the slide storage place then push gently until you see the end on
the other side of the slide storage place
fig.24.
Fold the Ultracord system back on the heel - fig.8.
Leave the iron (and the iron rest) to cool down for 1 hour.
You can then put your steam generator away, carrying it by the handle of the iron.
A problem with your generator ?
PROBLEMS CAUSES SOLUTIONS
The generator does not come
on and the thermostat light and
the on/off switch are not
illuminated.
The appliance is not switched on.
The “auto off system is activated.
Check that your appliance is correctly plugged in
and press the illuminated on/off switch.
Press the “restart” button.
Water runs out of the holes in
the soleplate.
Water has condensed in the
pipes because you are using
steam for the first time or you
have not used it for some time.
Press on the steam control button away from your
ironing board until the iron produces steam.
The soleplate is not hot
enough.
Decrease the steam output while ironing at low
temperature (steam output control dial on the
control panel). Wait for the thermostat light to go out before
activating the steam control button.
Contact an Approved Service Centre.
Water streaks appear on the
linen.
Your ironing board is saturated with water
because it is not suitable for use with a
steam generator.
Make sure you have a vented/mesh ironing board
White streaks come through
the holes in the soleplate.
Your boiler has a build-up of scale because
it has not been rinsed out regularly.
Rinse the anti-scale valve (see thedescaling
your generator” section).
Brown streaks come through
the holes in the soleplate and
stain the linen.
You are using chemical descaling agents or
additives in the water for ironing.
Never add this type of product in the water tank or
in the boiler (see for what water may be used). Contact an
Approved Service Centre.
Fabric fibres have accumulated in the holes
of the soleplate and are burning.
Clean the soleplate with a non-metallic sponge.
Your linen is not rinsed sufficiently or you
have ironed a new garment before washing it.
Ensure linen is rinsed thoroughly to remove any soap deposits or
chemicals on new garments which may be sucked up by the iron.
The soleplate is dirty or brown
and may stain the linen.
You are ironing at too high a
temperature.
See our recommendations regarding temperature
control setting.
You are using starch. Always spray starch on the reverse side of the
fabric to be ironed.
26

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Tefal GV8431 PRO EXPRESS bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Tefal GV8431 PRO EXPRESS in de taal/talen: Alle talen als bijlage per email.

De handleiding is 5,45 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info