637111
9
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
_ _ !i!_ _!_, !_ _!!_i!! i_ _!_!_!i__!_i_i !!i!,z!!! __ i!!_i_i!!_!!!!i_!_!__!i!_z_i!!_!!!!!!!_i!¸i_i_i!_!_!ii_ii!!!!_!i!!i!_i_i!!i!!!!_!!i!iiiiiii_!_!!iiii_i_!!!!_!iiii!_!_!_iiiiiiii_!_!!iiiiiiii_!!i!iiiii!_!_!iii!ii!iii_ii!i!i!i!i!i_iz!_i!!i!i!_ _:_ __:_____z_:_ __ __ _ _ __ ___ _ _ _ __ __ __ _¸_i_iiiii_i__z_i_iiiiiii!iiiii_ii_iiiiiii_i_i_iii_iii_i_i_i_iiii_i_i_iiii_i_i_i_i_i_i_iiiiiiiiii_i_i_iil
_iiiiiii_iiiii_iiiiii_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii iiiiiiiii_iiiiii_iiiiiiiiiiiiiii_iiii_i iiiiii!iiiiiiiiiiiiii_!iiiii!iiiii!ii!iiiiiii!iiiiiii_ iiiiii_iiiii_iiiii_iiiii_iiii_ii i_ iiii_iii _iii_ii_iiii_ii _ii_ i i_i ii_ i_iiiil _iiii_iii_i_i_i_i_i_i_ii_i_i_iii_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_ _i_'_'_ _'__i_'_'_'_ _ii_
Connect the AM loop antenna. /,_ Connect the right (R) and left (L) speaker
1. Attach the antenna holder to the rear panel of the "7' cables.
tuner/sound processor.
2. Clamp the AM loop antenna to the antenna holder and
connect the antenna terminal to the rear panel of the
tuner/sound processor.
3. Position the loop for the best reception.
Antenna holder
Press in until you hear a click.
AM loop antenna
Press hard enough to get it
fixed firmly in the place,
with a click.
You may attach the AM antenna holder with a screw (in-
cluded) to a rack or other structure. In this case, attach as
shown in _
-- -- Rack or other structure
To minimize noise pickup, keep the AM loop antenna cord
along the heat outlet grille, and away from the flat cables.
Be sure to connect speaker cables before connecting the
AC power supply cord.
eThe load impedance of any speaker used with this unit must
be 6-8£_.
Match the two wires from the left and right speaker cables
with the same colored levers of the speaker terminals, then
insert the wires into the respective terminals.
1. Strip off the outer
covering, and twist =_====,, _),
the center conductor. 15mm
2.
Make sure the bare ends of the wires are not unravelled.
(If they are, twist them tight again.) I'_
(For SC-CH717) I I_--_]
Insert the wire to the rear panel .._11_ I _
of the speakers, and then pull _ I
down the lever. _ "'J
(For SC-CH515)
Q Tilt the lever back
and insert the wire.
(_ Close the lever and
pull the cord gently
to be sure that it is
secured.
3. Insert the wire to the
rear panel of the
amplifier, and close the lever.
To prevent damage to circuitry, J,_F_ t
never short-circuit positive (+)
and negative (-) speaker wires.
Be sure to connect only positive (red) wires to positive (+)
terminals and negative (black) wires to negative (-) ter-
minals.
(For SC-CH717 only)
Connect the surround speaker cord.
Rear panel of Rear panel of
the amplifier the speakers
Connect the AC power supply cord after you
have connected all other cables.
9
9

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Technics-SC-CH515

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Technics SC-CH515 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Technics SC-CH515 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info