English English
Setting up the TEAM TruckerCom
Installation of a CB antenna
The antenna is one of the most important parts of the equipment. The type of antenna and its
location has a great effect on the range of operation. Please consider the following criteria for
selecting the best location and installation of your antenna:
> Make sure that the antenna is designed for radio operation on 27 MHz.
> The location of the antenna should be as high as possible without any obstacles nearby.
> The aerial cable should not be damaged and the plugs should be properly connected.
> Make sure that the antenna cable is not bent too strong.
> The bigger the mechanical size of the antenna, the higher the range of operation.
When you install a mobile antenna please note the following advice:
> The antenna should be fixed in the centre of a bigger part of the coachwork.
> The mobile antenna coil should have the closest possible contact with a conducting metallic
surface of the bodywork of the car.
There are also some other possibilities to fix the antenna onto the car without the necessity
to drill a hole into the bodywork of your car, for example mounting the antenna onto the gut-
ter, mounting the antenna onto a holder on the cover of the boot or using an antenna with a
magnetic foot or using a windscreen antenna.
For base-station operation we recommend a stationary roof-antenna.
> Please don't mount the CB antenna nearby a radio or TV antenna to prevent interference
of radio or TV reception.
> Keep an eye on power lines running along nearby when mounting the antenna on the roof.
" DANGER "
> The base-station antenna has to be connected via a lightning arrester.
> All connected cables including the antenna cable must not exceed a length of 4.5 m.
Aerial Connection
Before pressing the transmit key, a suitable aerial must be connected. The PL259 plug of the
aerial cable ( coax ) is connected to the SO239 socket (22) on the rear panel. Make sure, that
all plugs are firmly tightened and properly soldered. Unsatisfactory connections can damage
the radio and will reduce the range of operation.
The antenna should be matched with the radio, otherwise a part of the transmit power will be
reflected at the antenna and will not be radiated. This causes also a drop in the range of opera-
tion. The matching can be carried out by a length adjustment of the antenna radial for a minimal
SWR ratio which can be measured by an SWR meter. After the measurement the SWR meter
should be removed from the antenna line.
Installation in the car
When you want to fix the unit in your car, you can either fasten it with the help of the includ-
ed mounting bracket below the dashboard, or insert it into a car radio slot by using the includ-
ed inserting frame. Always mount the transceiver where the switches are easily accessible.
Other important points of view for the correct mounting position are:
> no interference of the roadworthiness,
> good access of the controls of the car,
> sufficient air circulation to prevent overheating of the radio in transmit mode.
TABLE OF CONTENTS
Setting up the TEAM TruckerCom
Installation of a CB antenna 15
Aerial Connection 15
Installation in the car 15 - 16
Microphone DM-915S 16
Power source 16
Operation of the TEAM TruckerCom
Switching on [ Vol / Off ] 17
Squelch [ ASQ ]17
Confirmation tones 17
Channel selection [ p] [ q]17
LCD background illumination [ LCD ] 17
Modulation selection [ AM/FM ]17
Norm selection [ DE/EC/EI/EU/PL/UK ]18
Transmitting 18
Call tone 18
CTCSS 18
Last channel recall [ LCR ]19
Priority Channel 9/19 [ CH9/19 ] 19
Scan [ SC ] and scan types [ SK / SB ]19
Dual watch [ DW ]20
Key lock 20
VOX [ VOX ] 20
External speaker jack 21
External signal meter jack 21
Additional Information
Safety Instructions 21
General Precautions 21
Servicing 21
Conformity 21
CTCSS list 31
Channel & Frequencies table 58
Specifications 59
14 15
