10
LISTENING TO A PROGRAM SOURCE
Operations
• Each time the STANDBY/ON button on the front panel, the
receiver is turned on to enter the operating mode or off to
enter the standby mode.
• On the remote control, press the ON button to enter the
operating mode or press the STANDBY button to enter the
standby mode.
1. In the standby mode, turn the power on.
• This unit enters the standby mode and the STANDBY indi-
cator lights up.
This means that the receiver is not disconnected from the
AC mains and a small amount of current is retained to sup-
port the operation readiness.
• To switch the power off, push the POWER switch again. Then
the power is cut off and the STANDBY indicator turns off.
Before operation
• Push the POWER switch.
2
. Switch the desired speakers on.
• You can select the various combinations of speakers
depending on where the speakers C or/ and D are installed.
• Each time the MAIN ZONE SPEAKER (A/B) SELECTOR
button is pressed, the speakers are switched on or off as fol-
lows :
( ) : When the SUB ZONE mode is set to on.
• Each time the SUB ZONE SPEAKER (C/D) SELECTOR
button is pressed, the speakers are switched on or off as fol-
lows :
( ) : When the SUB ZONE mode is set to on.
• When using the headphones for private listening, switch off
all the speakers installed in the main room.
∑Note :
• To use SUB ZONE function, you should install speakers C
or/and D in another room (SUB ZONE) and set the SUB
ZONE mode to on. (For details, refer to "CONNECTING
SPEAKERS" on page 6 and "SUB ZONE PLAYBACK" on
page 21.)
