586128

Taurus Striker Slim robot Handleiding

13
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
During charging, the battery charging/battery full indicator lamp will pulse.
Once the battery is completely charged, the battery charging/battery charged
indicator lamp will remain green (D).
Approximately 4 hours are needed for a complete charge of the battery. Never
attempt to over-charge the battery.
Assembling the battery/s
- CAUTION: During the handling of batteries, do not touch both poles at the
same time, as this will provoke the partial discharge of the stocked energy
therefore affecting longevity.
- Make sure the on/off switch is in the “0” position before installing the batteries.
- Remove the cover of the battery compartment.
- Put the battery in its compartment, respecting the polarity (Fig. 1).
- Close the cover of the battery compartment.
Assembling the side brushes:
Place the side brush on the side brushes holder.
Press until you hear a click. (Fig.2)
Instructions for use
Before use:
- Before using this product for the rst time, it is important to make a full charge
of batteries.
Use:
- Turn the appliance on using the on/off switch.
- The appliance will begin to function automatically until its batteries run out.
- While the appliance is operating the battery charging/battery charged and
battery low indicator lamps will alternate.
- When the batteries are low, the red battery low indicator lamp will light up.
- When the deposit is full, the full deposit indicator lamp will come on and the
deposit must be emptied.
- When using the robot on a dark surface, set the height sensors at Position
2 or 3 (Fig. 3).
Once you have nished using the appliance:
- Turn the appliance off, using the on/off switch.
Cleaning
- Disconnect the appliance from the mains and let it cool before undertaking
any cleaning task.
- Disconnect the charger from the mains and let it cool before undertaking any
cleaning task.
- Remove the battery before starting any cleaning operation.
- Clean the equipment with a damp cloth with a few drops of washing-up liquid
and then dry.
- Do not use solvents, or products with an acid or base pH such as bleach, or
abrasive products, for cleaning the appliance.
- Do not let water or any other liquid get into the air vents to avoid damage to
the inner parts of the appliance.
- Do not submerge the appliance in water or any other liquid, or place it under
a running tap.
- Never submerge the connector in water or any other liquid or place it under
running water.
Emptying the dust box:
- Empty the dust box each time after use.
- Open the lid of the dust box. (Fig.4)
- Disconnect the dust box from the appliance.
- Open the dust box emptying lid and empty its contents into a suitable rubbish
bin (Fig.5)
- Check the condition of the dust box lter and replace it.
- Close the lid of the dust box.
- Attach the dust box to the appliance.
Changing the lters:
- It is recommended that the dust box lter should be changed every three months.
- To remove lters:
- Open the lid of the dust box. (Fig. 4)
- Disconnect the dust box from the appliance.
- Open the dust box emptying lid and remove the dust box lter from its
bracket. (Fig.5)
- To reassemble the lter, proceed with the above instructions, in reverse order.
Changing side brushes:
- To remove the side brushes.
- Pull the bristles of the brush until it disengages from the side brush assembly.
(Fig.6)
- To install side brushes, proceed with the above instructions in reverse order.
Supplies:
Supplies can be acquired from distributors and authorised establishments
(such as lters, etc.) for your appliance model.
Always use original supplies, designed specically for your appliance model.
Anomalies and repair
Problem
Solution
1 The low battery indicator lamp is lit.
The battery is low.
Recharge the battery.
2 The robot has not started.
The on/off button is in the “0” position.
The dust box lter is badly tted.
Operate the robot’s on/off button.
Fit the dust box lter correctly.
3
The battery charged indicator continues to
pulse after 48 hours of charging.
During the charging process, the current has been
cut off, so the appliance has not been charged
properly.
Repeat the charging process.
4 The side brushes are deformed. They are worn out.
Remove the side brushes and soak them in hot
water to recover their usage shape.
5 The robot does not start up.
The battery is incorrectly tted.
The battery is too low.
Fit the battery correctly.
Charge the batteries of the appliance.
6
The appliance goes in circles and never in a
straight line.
There may be problems with the wheels.
Contact our customer service department to repair
them.
7
During the rst time of using the appliance, its
autonomy is lower than normal.
The battery has not completely recovered its
charge.
Repeat the charging process.
8
The appliance moves backwards after
switching it on
The appliance is on a coloured surface (low reec-
tion of the light against the surface)
Adjust the height sensors to Position 2 or 3.
- In case of breakdown call the customer service telephone number indicated in
the guarantee sheet. Do not attempt to disassemble it or repair it as this could
be dangerous.
- If the connection to the mains has been damaged, it must be replaced and
you should proceed as you would in the case of damage.
For EU product versions and/or in case that it is requested in your country:
Ecology and recyclability of the product
- The materials of which the packaging of this appliance consists are included
in a collection, classication and recycling system. Should you wish to dispose
of them, use the appropriate public containers for each type of material.
- The product does not contain concentrations of substances that could be
considered harmful to the environment
This symbol means that in case you wish to dispose of the
product once its working life has ended, take it to an authorised
waste agent for the selective collection of waste electrical and
electronic equipment (WEEE)
This symbol means that the product may include a battery or
batteries; the user must remove them before disposing of the
product. Remember that batteries must be disposed of in duly
authorised containers. Do not dispose of them in re.
Manual Striker Slim.indb 13 17/05/13 13:53
… 13 …

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Taurus Striker Slim robot bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Taurus Striker Slim robot in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Portugees, Spaans, Pools als bijlage per email.

De handleiding is 5,25 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info