Instructions for use
Before use:
- Remove the appliance’s protective lm.
- Some parts of the appliance have been
lightly greased. Consequently, the rst time
the appliance is used a light smoke may be
detected. After a short time, this smoke will
disappear.
Filling with water:
- It is essential to have lled the deposit with
water to be able to work with steam.
- Open the lid of the lling mouth.
- Fill the compartment with cold water.
- Fill the deposit taking care to observe the
MAX level (Fig.1).
Use:
- Unroll the cable completely before plugging
it in.
- Connect the appliance to the mains.
- The pilot light (10) comes on.
- Turn the thermostat control to the desired
temperature position.
- Do not use temperatures higher than those
indicated on the garments to be treated.
● Temperature for synthetic bres
(Polyester, Nylon…).
●● Temperature for silk, wool.
●●● Temperature for cotton.
(Minimum temperature for ironing with steam)
Max Temperature for linen.
- If garment has various kinds of bres, select
the temperature for the bre that requires the
lowest temperature. (For example, select the
temperature for polyester for an article made
out of 60% polyester and 40% cotton).
- Wait until the pilot light (10) has gone out
which will indicate that the appliance has
reached an adequate temperature.
Steam Ironing:
- It is possible to iron with steam whenever
the deposit is lled with water and the
adequate temperature is selected.
Steam ow control:
- The appliance has a (9) control knob that
allows to get the control of the steam ow.
Spray:
- The spray can be used in both steam and
dry ironing.
- Press the spray button (1) to use this
operation.
- The spray button has to be pressed
repeatedly to release the rst spray.
Steam blast:
- This function proportions extra steam for
eliminating wrinkles.
- Press the steam blast button (2). Wait a few
seconds until vapour penetrates the bres of
the garment before pushing the button again.
For optimum steam quality, do not apply more
than three successive blasts.
- The spray button has to be pressed
repeatedly to release the rst spray.
Once you have nished using the
appliance:
- Select the minimum position (MIN) using the
thermostat control.
- Unplug the appliance to the mains.
