20
How to Use
21
How to Use
10
Display of results
The trunk % fat percentage and visceral fat
levels are displayed on the upper and lower
bar, respectively.
*The main unit buzzer will sound twice when the
results have been displayed (beep, beep).
*Refer to pages 32 and 33 for how to read
results.
11
Storing the impedance meter
Always store the impedance meter in the main unit upon completion of
measuring (the impedance meter transfer mode will end and the meter will
return to a state ready for use).
12
For Your Reference
Take care not to catch the body hair or skin of the
subject when moving the impedance meter on
the abdomen. Use both hands on either side of
the impedance meter, as shown in the diagram.
Please…
Pillows can cause errors in
measurements. Avoid using
as much as possible.
1.Slide the
impedance
meter down
from the top.
2.Hang the
switch hanger
on the main
unit hook
Press the key on the main unit
to turn on.
The initial screen is displayed.
This mode allows measurements to be easily
taken when the waist of subject is too big to
be accommodated by the main unit.
Place the main unit close to the supine
subject as shown in the diagram below.
*The main unit will switch off
automatically after two minutes in
the absence of any operation.
1
Press the key to change
the mode.
*At right is the screen when the [over 130cm]
mode is selected.
2
*Blue print in display illustrations indicates parts that illuminate or flash.
For Your Reference
Please use the tip of a pen or other fine
instrument to press the key (taking
care not to damage the unit).
Check that the
Power LED is off
Suitably firm surface
(thin mat, examination table, etc.)
Measuring
standard mode (cont’d)
Measuring
waist circumferences over 130cm
End measuring
Press the key on the main unit to turn off.
*If the main unit power is not turned off, it will automatically turn off after results
have been displayed for approximately two minutes.
