– 24 – – 25 – 2524
BOXX – Radio-controlled alarm clock with thermometer
Note on radio-controlled time
The time base for the radio-controlled time is a caesium atomic clock operated by the Physikalisch Technische Bundesanstalt
based in Braunschweig (Brunswick), Germany. It has a time deviation of less than one second in one million years. The time is
coded and transmitted from Mainflingen near Frankfurt via the frequency signal DCF-77 (77.5 kHz) and has a transmitting
range of approximately 1,500 km. Your radio clock receives the signal, converts it and always shows the exact time. The
adjustment to Daylight Saving Time (summer/winter time) is automatic. In Daylight Saving Time DST is shown on the display.
The reception quality depends mainly on geographic location. Normally there should be no reception problems within a 1,500
km radius around Frankfurt.
Therefore, please note the following steps:
• The recommended distance to any interfering sources like computer screens or TV sets is at least 1.5 - 2 meters.
• Within concrete walls (reinforced with steel) such as basements, the received signal is naturally weakened. In extreme
cases, please place the unit close to a window to improve reception.
• During night-time, the atmospheric interference is usually less severe and reception is possible in most cases. A single
daily reception is adequate to keep the accuracy deviation under 1 second.
8. Operation
• Press and hold the
▲
or
▼
button in the respective setting mode for quick setting.
BOXX – Radio-controlled alarm clock with thermometer
• The device will automatically quit the setting mode if no button is pressed for 30 seconds.
•Important: The device cannot be operated during the DCF time-signal reception.
8.1 Manual setting of the clock and calendar
• Press and hold the SET button in normal mode to enter the setting mode.
• The hour digit flashes. Press the
▲
or
▼
button to adjust the hours. Press the SET button to make the settings in the fol-
lowing sequence: minutes, year, month, date and time zone (ZONE 00 - default). Press
▲
or
▼
button to adjust it.
• Confirm the setting with the SET button.
• The manually set time is overwritten once the DCF time signal is successfully received.
8.1.1 Time zone setting
• You can make the time zone correction (+12/-12) in setting mode.
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
8.2 12 or 24 hour system
• Press 12/24/
▼
button in normal mode to choose 12 HR or 24 HR system. In the 12 HR system AM or PM (after 12
o'clock) appears on the display.
TFA_No. 60.2554_Anleitung 24.05.2019 11:47 Uhr Seite 13
