35
Battery replacement
•
Replace the batteries when the battery symbol of the weather station appears near the
weather icon.
•
When the batteries of the transmitter are used up, the low battery icon appears above
the outdoor humidity display.
Note:
In the event of changing batteries in any of the units, all units need to be reset by following
the setting up procedures. This is due to a random security code assigned by the transmitter
at start-up. This code must be received and stored by the weather station in the first 3
minutes of power being supplied to the transmitter.
SETTING UP
1. First, insert the batteries in the transmitter (see “To install and replace batteries in
the thermo-hygro transmitter” above).
2. Within 2 minutes of powering up the transmitter, insert the batteries in the weather
station (see “To install and replace batteries in the weather station” above). Once
the batteries are in place, all segments of the LCD will light up briefly. Following the
indoor temperature/humidity and the time as 00:00 will be displayed. If this information
is not displayed on the LCD after 60 seconds, remove the batteries and wait for at least
60 seconds before reinserting them. Once the indoor data is displayed user may
proceed to the next step.
3. After the batteries are inserted, the weather station will start receiving data signal from
the transmitter. The outdoor temperature and humidity data should then be displayed
on the weather station. If this does not happen after 2 minutes, the batteries will need
to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, the distance between the
