When the dive computer is in the permanent Error mode, only the Er warning is shown
in the center window. The dive computer does not show times for ascent or stops.
However, all the other displays function as before to provide information for ascent.
You must immediately ascend to a depth of 3 to 6 m/10 to 20 ft and remain at this
depth until air supply limitations require you to surface.
After surfacing, you should not dive for a minimum of 48 hours. During the permanent
Error mode, the Er text is displayed in the center window and the planning mode is
disabled.
5.6. Air integration
The Cobra3 can be attached to the high-pressure port of the regulator, enabling you
to receive cylinder pressure and remaining air time data.
5.6.1. Connecting Suunto Cobra3 to a regulator
When purchasing the Suunto Cobra3, we strongly recommend that you have your
Suunto representative attach it to the first stage of your regulator.
However, if you decide to attach it yourself, follow the steps outlined below:
1.
Remove the high pressure (HP) port plug on the first stage of your regulator using
an appropriate tool.
2.
Thread the high pressure hose of the Suunto Cobra3 into the HP port of your
regulator with your fingers. Tighten the hose fitting with a 16 mm (5/8'') wrench.
DO NOT OVERTIGHTEN!
3.
Attach the regulator to the scuba cylinder and slowly open the valve. Check for
leaks by submerging the regulator first stage in water. If leaks are detected, check
the condition of the O-ring and sealing surfaces.
38
