using a new aroma oil. Alternatively, you can put the oil directly into the aroma oil container, but not
directly into the water tank.
Picture 1 Picture 2
Picture 3 Picture 4
Please be careful when moving the appliance. Since the appliance uses compressed air to generate
the water mist, the base of the appliance is not sealed airtightly. Therefore, always keep the appliance
straight to avoid leaking water.
• Please connect the appliance to the power supply. The indicator lights light up for one second and the
appliance enters the standby mode. You can use the control panel on the appliance or the remote
control for further operations. Both have the same functions.
• Press the on-/off-button on the control panel to start the appliance. The standard setting with high mist
output level is activated. In addition, the environmental temperature in °C and the current relative air
humidity in % are shown on the LED display.
• Mist output level control “Humidity”: To change the mist output level, use the mist output level control.
The appliance has three mist output levels (high, medium and low), which are indicated by the number
of bars on the LED display: high - full bar blocks, medium - three bar blocks, low - one bar block.
• Timer function “Timer”: To activate the timer function, press the timer button. You can choose between
1-12 hours. Once you have selected your desired time, wait five seconds until the number stops blinking.
The active timer is indicated by an indication light on the LED display. The display also shows the
environmental temperature and the remaining hours in alternation, as well as the relative humidity in %.
If you hold down the timer button for two seconds, both the LED display and all indication lights will go
out except for the blue lamp in the water tank. To switch them on again, press any button. When the set
time is over, the appliance will turn off automatically.
If you want to switch off the timer function, press the timer button again. The timer indication light
disappears from the display.
• Heating function “Heat”: By pressing the heating function button, the water within the water tank will be
heated. Once the appliance has heated the water, the mist will leave the nozzle 2-3°C warmer than
room temperature, which prevents the room temperature from sinking during operation.
• Sleep mode “Sleep”: When the sleep mode button is pressed, all indicator lights will go out except for
the indicators for the on-/off-button and for the sleep mode. The previous set mist output level will be
changed to the lowest mist output level. When pressing the button again, the sleep mode will be
deactivated and previous settings will be restored.
• Humidity regulation “Humidity Setting”: Press the button for the humidity regulation to set your desired
air humidity in %. You can choose between 40-80%. A comfortable air humidity is achieved with 40-
60%. Please wait five seconds after selecting until the appliance has accepted the setting. When the
humidity regulation is activated, the corresponding indication light is shown on the display. As soon as
the current air humidity has reached your set, desired air humidity level, the appliance automatically
switches to standby mode. If the current air humidity level drops below the set air humidity, the appliance
switches back to the operating mode. If you want to turn off the humidity regulation, press the button
again and select “- -“. Please wait five seconds until the indication light on the display goes out. The
humidity regulation is deactivated and the appliance enters the continuous operation until it is turned off
by the timer or manually.
• The appliance will turn off automatically when there is no water in the water tank.
