Operation
• After switching on or switching over, the fan runs. The compressor and cooling capacity start as soon
as the set temperature in cooling mode is lower than the room temperature.
• Operating voltage: 220-240V~, 50Hz
• Control panel: Display
Temperature - Operation mode
On/Off Ventilation speed Timer
Temperature + Signal receiver
remote control
• Remote control:
1. SPEED: Ventilation speed
2. TEMP+: Temperature +
3. MODE: Operation mode
4. TEMP-: Temperature -
5. TIMER: Timer
6. POWER: On/Off button
• The unit reaches the following temperatures during operation:
o Maximal Cooling: in dry environment 35°C, in wet environment 24°C
o Minimal Cooling: in dry environment 18°C, in wet environment 12°C
• Make sure that the exhaust hose is installed properly before operation, then plug in the unit, but do not
use a multiple socket. Press „POWER“ to turn on the unit.
• If you use the cooling and dehumidification functions, please keep an interval of at least 3 minutes
between the two operations.
• Operation mode cooling:
o Press „MODE“ until the indicating light „COOL“ lights up.
o Press the buttons „TEMP+“ and „TEMP-“ to adjust the desired room temperature between 16°C
and 31°C.
o Press „SPEED“ to adjust the ventilation speed.
• Operation mode dehumidifying:
o Press „MODE“ until the indicating light „DEHUM“ lights up.
o The selected temperature will be set to current room temperature minus 2℃. The ventilation
speed is set as „LOW“ automatically.
• Operation mode ventilation:
o Press „MODE“ until the indicating light „FAN“ lights up.
o Press „SPEED“ to adjust the ventilation speed.
• Timer for turning on the unit:
o Press „TIMER“ while the unit is off and set the desired time at which the unit shall turn on by
using the buttons „TEMP+“ and „TEMP-“ between 0 and 24 hours.
o Press „TIMER“ again to confirm. The display shows the set time.
• Timer for turning off the unit:
o Press „TIMER“ while the unit is on and set the desired time at which the unit shall turn off by
using the buttons „TEMP+“ and „TEMP-“ between 0 and 24 hours.
o Press „TIMER“ again to confirm. The display shows the set time.
• Continuous drainage:
o If you plan to leave this unit unused for a long time, please remove the rubber blockage from
