The heater should only be operated at minimum distance of 50cm from any wall or other object. Position the air
flow in order to optimize the heating of the room. Avoid corners, small volumes, floors and ceilings.
1.
Plug into any 220-240V~50/60Hz, AC source.
2.
Your heater is equipped with 4-position rotary switch
SYMBOL FUNCTION
0 OFF
*
Fan without heater
I
750W (Low heat output)
II
1500W (Full heat output)
Thermostat
Left OFF
Right Maximum
3.
Set the rotary switch to maximum for fast warm up of a room. Once the temperature of room is comfortable,
select a lower setting to reduce electrical consumption and to prevent the room from becoming too warm.
4.
If you selected low or full output, choose the desired temperature with the thermostat. With the Thermostat,
the temperature can be regulated steplessly. When the desired temperature is reached, the unit will
automatically switch off. Once the temperature has fallen below the pre-set level, the heater will switch on
again.
5.
Pilot light will allow you to check the thermostatic regulation. When the appliance is heating, this pilot light will
be on. It will go out when the desired temperature is reached.
6.
Before removing the plug from the socket, switching off and better work for 30-60 second with cool air in
condition that protecting inner parts.
Swing button:
This appliance also has a swing function. To switch the function on, press the swing switch. To stop it, press the
swing switch again.
This heater is protected with an overheat protection that switches off the appliance automatically in case of
overheat, e.g. due to the total or partial obstruction of the grids. In this case, unplug the appliance, wait about 30
minutes for it to cool and remove the object which is obstructing the grids. Then switch it back on as described
above. The appliance should operate normally. Should the problem persist, please contact your retailer.
To avoid damage and danger by overheating, your heater is fitted with super protector that switch as off the
heater in the event of overheating until the temperature drops to some extent.
1.
When your heater needs cleaning, wipe exterior surfaces of the heater with a moistened cloth. Not rinse with
water directly. Be sure to unplug before cleaning.
2.
To prolong the heater life, not disassemble it personally when malfunction occurs. Send your heater to your
retailer for the convenience inspecting.
Power supply: 220-240V~50/60Hz
Power regulation range: 750/1500W
