Operation:
1. Turn the On/Off button and the “Heat” button to “OFF” position, then plug the
appliance to the mains
2. Turn the operation knob clockwise until a “click” sound.
3. Turn the knob to the desired moisture.
4. Press the “Heat” button, yellow operation light (Heat) is switched on, water
temperature and the warm mist amount will be increased.
5. Refill water when red operation light (Empty) is switched on and the appliance will
turn off automatically.
6. Ionizer function will be automatically created by turning on the operation knob. By
turning off the operation knob, the ionizer function will be automatically stopped.
Attention:
1. To avoid electric shock, do not touch the mains when your hands are wet.
2. Do not cover the mist outlet/nuzzle, mist must not be obstructed.
Cleaning:
Clean the appliance at least once a week (2 Steps).
Step 1:
1. Remove the water tank.
2. The base may be cleaned with mild soap and warm water, brush the shake
implement and etc slightly.
Step 2:
- Sterilization (base and water tank)
Mix 1 teaspoon of bleaching agent with 5 liters of water, leave for 20 minutes, shake
the water tank for a few seconds.
Attention:
Do not scrub the appliance surface of the base or the tank as this will leave
permanent scratches.
Change the Ultrasonic transducer chip:
The Ultrasonic transducer chip is the main component to produce the mist. When
operating by using hard water, there will be mineral deposition on the transducer chip.
Even if the product is equipped with a water filter you have to clean the chip
periodically. When mineral deposition is too serious, the transducer chip should be
