Special Features
1. Instantly to full power of heating
2. Degrees of protection: IP 24
3. Electronic thermostat control setting
4. Anti-Frost function
5. Safety thermal cut off
6. Light weight
7. Quiet
8. No oil-leakage
9. Towel rails to hang and dry towels
SPECIFICATIONS for HEAT SUPREME
Voltage rating: 230V AC, 50/60Hz
Power consumption: 1000W
Unit size: ca. 59.5cm(L) × 80cm(H) × 21.5cm(W)
Unit weight: ca. 9,35 kgs
Unit Layout Electronic version (HEAT SUPREME)
REMOVE PACKAGING
Please read all the instructions before using this heater
1. Take out the heater from gift box.
2. Remove the polyfoam and polybag.
3. Inside are: 1 bag with 1 Mounting Support, 4 screws, 4 Mounting Anchors for wall mounting
4. 4 screws to fix the rails. Save the packaging for storage when the heater is not been used or
in summer season.
RACKS INSTALLATION
Screw the rails on the heater using the 4 special screws. It has to be done before the installation of the
heater on the wall.
LOWER WALL MOUNTING SUPPORT INSTALLATION
In the same polybag than the screws, there are 2 metal parts to fix at the bottom of the rear of the heater. Use
the 2 small screws, tighten firmly.
INSTALLATION
Heater has to be mounted minimum 0.7m from the floor and no object (e.g. Shelf) should be placed within
1m from the top of the heater.
We recommend to install the heater in the bathroom area at least 0.6m away from shower OR bathtub as
shown in the picture (volume 3). The figure 0.6m is a suggested distance; the actual distance from the
shower and bathtub should follow national standard in each country
Once the racks are mounted, you can start the following steps to install the heater on the wall.
STEP I: Mark the left or right screw hole position using a pencil on the wall (about 1.5 meter from floor)
STEP II: Drill a hole
STEP III: Hammer the screw anchor into the hole
STEP IV: Screw lightly the mounting support on the wall
STEP V: Mark another screw hole on the wall at the same level than the first one and at a distance of 138mm
approximately
STEP Vl: Drill second hole
STEP VII: Hammer another screw anchor into the hole
STEP VIII: Screw tightly the mounting support
STEP IX: Install the heater on the mounting support. Using a pencil, mark the screw holes (left and right)
