11
Structure
1. Handle
2. Rear grille
3. Oscillation button
4. Speed controller
5. Front grille
6. Stand
Assembly
• Remove the wing screw from the motor pain.
• Fit the rear cage onto the motor pain. Make sure that the two holes on the motor
match the two holes on the rear cage. Fit the wing screw and screw it on firmly.
• Put the blade on the motor pain and carefully tighten the screw.
• Fit the front cage onto the rear cage and fix them together using the metal clips.
Tighten the small screw.
• Loosen the screw at the bottom of the bar, insert the bar into the stand and tighten
the screw by hand to secure the bar to the stand.
• Please loosen the screws at the top of the bar and connect the fan head to the
bar.
Operating instructions
The fan has 3 speed settings:
0 = Device off
I = Low speed
II = Medium speed
III= High Speed
The fan can operate in oscillating or stationary mode. Press the oscillation button to
activate or deactivate the oscillating mode.
Technical information
Operating Voltage: 220-240 V~ 50Hz
Power Consumption: 35 W
Cleaning
• Always disconnect the appliance from the power outlet before cleaning. Never
immerse the appliance in water to prevent electric shocks.
• Wipe over the exterior of the appliance with a soft wet cloth and then wipe dry with
a dry cloth.
• Please do not use any aggressive or chemical cleaning agents or abrasive
