- 7 -
you should be able to smell the fuel gas .Since Propane (LP) is heavier than air you should smell for the gas odor low
to the floor. ANY GAS ODOR IS YOUR SIGNAL TO GO INTO IMMEDIATE ACTION!
• Do not take any action that cloud ignite the fuel gas. Do not operate any electrical switches. DO not pull
any power supply or extension cords. Do not light matches or any other source of flame. Do not use your
telephone.
• Get everyone out of the building and away from the area immediately.
• Propane (LP) gas is heavier than air and may settle in low areas. When you have reason to suspect a
propane leak, keep out of all low areas.
• Use your neighbor's phone and call your fuel gas supplier and your fire department. Do not reenter the
building or area.
• Stay out of the building and away from the area until declared safe by the firefighters and your fuel gas
supplier.
• FINALLY, let the fuel gas service person and the firefighters check for escaped gas. Have them air out the
building and area before you return. Properly trained service people must repair any leaks, check for
further leakages, and then relight the appliance for you.
OPERATION
LIGHTING INSTRUCTIONS
Check and ensure that an AA battery is inside the ignition chamber
And has power. Ensure the anode (+) faces outside.
TO TURN THE HEATER
1. Turn on the valve on the gas supply cylinder completely.
2. Push the control knob in it and turn it the "pilot" position.
3. Press the "igniter" button several times to light the burner. Hold it for 5
seconds. Release the Control Knob after the burner lights.
4. Turn the Control Knob to switch to desired temperature position.
·Turn the knob to "LOW" position for small flame. See picture of " ".
·Turn the knob to "HI" position for big flame. See picture of " ".
Note:
