PART 1 • English
21
English
n PID (BLUE Button): You can search a specific channel by entering the PID value of a
channel. If you press the BLUE (PID) button, the PID screen is displayed. Enter the
PID value and press the BLUE button again. To cancel the PID value, press BACK on
the remote control or press the BLUE (PID) button to search the channel. You should
enter V-PID, A-PID and P-PID as described in “Editing channels from the channel list”
(Described in section 5.1.1)
Tip: Check the level and quality of the signal bar before searching any channels.
The signal level of the TP of the current satellite is displayed. The GREEN bar
is displayed if the settings are correct, otherwise the RED bar is displayed and
you cannot get the channel. In the latter case, check if your dish is aimed at
the selected satellite or if the DiSEqC switch of the LNB overlaps with another
satellite. Also, change the Frequency with the LEFT/RIGHT button until the
GREEN bar is displayed to get the valid transponder. If you press the RED
(Auto Scan), GREEN (Net. Scan), YELLOW (TP Scan), or BLUE (PID) button
the channel searching status is displayed.
5.1.4.3.1 Positioner Set-up
(if you are using a Motorised positioner with DiSEqC1.2)
If you are using a motorised positioner with DiSEqC 1.2 you will have to set the positions of the satellites
you want to scan. This function is available only if in the “LNB Set-up” menu and the LNB Dish field is set
to “Moved”. (As described in “LNB Set-up” (Described in section 5.1.4.2).
Before you start:
1. Make sure that your installer has set the centre position of your dish.
2. Make sure that the mechanical limits of your motor are set, so that no damage can be done
to your dish by moving it too far to the East/West.
3. Make sure you set the highest Symbol Rate (Ksymbols/sec) for your chosen transponder
(TP). The Signal level and Quality indicator will help you set up the best dish
position possible.
4. Use your UP/DOWN buttons to select the “Dish Position” field in the “Channel Set-up” menu.
( Note that the LNB dish in the LNB setup menu is set to “Motorized”.)
5. Press the OK button and the “Positioner Set-up” Menu will be displayed.
6. Start setting the position of the selected satellite.
7. Use your UP/DOWN buttons to go to field “Centre” and use your LEFT/RIGHT buttons to
put the centre field to “On”.
8. Press OK, and your dish will move to the centre position. It takes your dish maximum 30
seconds to move to its central position.
9. To know in which direction you will need to move your dish, you will need to know the
position of the satellite you want it to position to.
