PART 3 • English
59
2.2 Rear Panel
(Please see inside cover Figure 2)
1. ANTENNA INPUT Connect the antenna cable to this connector.
2. RF OUTPUT Gives you the possibility to bypass anologue signals from
your antenna to your TV, VCR or another equipment.
3. AUDIO Right (Red RCA) and Left (White RCA)
These connectors give you the possibility to connect the
audio signal to an external amplifier or to the audio input of
your TV.
4. VIDEO (Yellow RCA) This connector has a constant video signal for additional
VCR-connections.
5. TV Scart Connector
(for TV or VCR) Use this connector to connect your receiver to your TV or
video recorder using a scart cable.
6. RS 232 Serial Port This serial port can be used to connect your PC to your
receiver, and enables you to download new versions of
software into your receiver. Detailed information about
downloading software into your receiver can be found on
our website (www.strongsat.com).
Note:
It is recommended to ONLY use the original software provided via our website.
Loading other versions of software not adapted to your model number can cause
severe damage to your receiver, and will not be covered by the warranty.
7. S/PDIF Use this coaxial output to connect your receiver to the input
of your digital audio amplifier.
8. Power Cord: Your receiver requires a mains voltage supply of 110-240 V
AC (Auto-selectable), 50/60 Hz +/- 5%. Make sure to check
the power specification of the wall outlet before connecting
your receiver to the main power.
