If the engine starts but does
not keep running, repeat the above steps with
the throttle on «FAST».
STARTING THE ENGINE (hot starting)
•) Follow the whole cold-starting procedure
with throttle control (1) in «FAST» position.
USE OF THE ENGINE IN OPERATION
When mowing, use the engine at its max rpm by
moving the throttle control to «FAST» position.
Keep your hands away
from the silencer and surrounding areas
that can become extremely hot. With the
engine running, do not get loose-fitting
clothing (ties, scarves, etc.) or hair closer to
the top part of the engine.
Do not operate on over 20°
inclines to prevent malfunctioning of the
engine.
STOPPING THE ENGINE DURING
MOWING
a) Move the throttle (1) to «SLOW».
b) Stop the engine as described in the
machine’s instructions manual; in the case of
engines with electric ignition, move the throt-
tle to «STOP», or turn the key (3) (if present)
to «OFF».
STOPPING THE ENGINE AFTER
MOWING
a) Move the throttle (1) to «SLOW».
b) Stop the engine as described in the
machine’s instructions manual; in the case of
engines with electric ignition, move the throt-
tle to «STOP», or turn the key (3) (if present)
to «OFF».
c) When the engine is cold, disconnect the
spark plug (4) and remove the key (3) (if pres-
ent).
d) Remove all traces of debris or dirt from the
engine and especially around the exhaust
silencer to reduce the risk of fire.
5.6
5.5
IMPORTANT
̆
!
WARNING!
5.4
5.3
NOTE
CLEANING AND STORAGE
a) Do not spray with water or use hydraulic
lances to clean the exterior of the engine.
b) Preferably use a compressed air gun (max. 6
bars), to prevent debris, dirt or dust from pen-
etrating inside the machine.
c) Store the lawnmower (and the engine) in a dry
place, sheltered from severe weather condi-
tions and sufficiently ventilated.
LONG STORAGE (over 30 days)
In case the engine has to be stored for a long
time (for example at the end of the season), a
few precautions are needed to help the future
start-up.
a) Drain fuel from tank to prevent build-ups
inside the tank.
b) Remove the spark plug and pour inside the
spark plug hole about 3 cl of clean engine oil.
Close the hole with a cloth, then pull, slowly
and carefully, the starting rope so that, with a
few engine revolutions, the oil will be distrib-
uted on the cylinder inner walls. Reinstall the
spark plug without connecting the cable cap..
5.8
5.7
5
EN
