575794
11
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
ENGLISH
GB
Do not use the machine if the safety sys-
tem is not working! Take the machine
to a service workshop for inspection!
STARTING ENGINE
1. Open the fuel cock (fig. 12).
2. Make sure that the spark plug cable is properly
in place.
3. Check to make sure that the power take-off is
disengaged.
4. Do not keep your foot on the drive pedal.
5a. Comfort-President:
Starting cold engine – put the throttle control in the
choke position. Starting warm engine – put the
throttle control at full throttle (approx. 1 cm behind
the choke position).
5b. Royal-Pro16-Pro20:
Put the throttle control at full throttle. Starting cold
engine – pull the choke control out fully. Starting
warm engine – do not touch the choke control.
6. Depress the brake pedal fully.
7. Turn the ignition key and start the engine.
8a. Comfort-President:
Once the engine has started, move the throttle con-
trol gradually to full throttle if the choke has been
used.
8b. Royal-Pro16-Pro20:
Once the engine has started, push the choke control
in gradually if it has been used.
9. When starting from cold, do not make the ma-
chine work under load immediately, but let the en-
gine run for a few minutes first. This will allow the
oil to warm up.
When in use, always operate the engine at full
throttle.
STOPPING
Disengage the power take-off. Apply the parking
brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
Shut off the petrol cock. This is particularly impor-
tant if the machine is to be transported on a trailer
for example.
If the machine is left unattended, re-
move the spark plug cable from the
spark plug. Also remove the starter key.
The engine may be very warm immedi-
ately after it is shut off. Do not touch the
silencer, cylinder or cooling fins. This
can cause burn injuries.
CATALYTIC CONVERTER
(Pro20 Cat)
The catalytic converter gets very hot during opera-
tion. The heat remains for a long time after the en-
gine has been stopped. Be aware of the fire risk.
Do not park in close proximity to in-
flammable objects. Do not cover the
machine until the catalytic converter
has cooled down.
STEERING AID (Pro20)
Built-in function in order to facilitate steering. The
operator only has to turn the steering wheel gently.
A hydraulic torque amplifier creates the remaining
force.
As opposed to normal servo steering (e.g. in a car),
the steering aid has a limited capacity. This means
that it has some characteristics that might be con-
sidered negative:
- at a low engine rpm or in situations where extra
steering force is needed, steering can be consid-
ered to be “jumpy”.
- the machine should always be moving when the
steering is used. Avoid turning the steering
wheel when the machine is standing completely
still and the accessory is in the lowered working
position.
The steering is adapted in order to produce better
results at a normal working speed. This produces
major benefits.
Even when the engine is not running, the steering
works. However, it is harder to turn in this case, if
the machine is to be manoeuvred manually.
DRIVING TIPS
Make sure that there is the correct quantity of oil in
the engine when driving on slopes (oil level on
“FULL”).
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Stiga PARK PRO 16 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Stiga PARK PRO 16 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Stiga PARK PRO 16

Stiga PARK PRO 16 Gebruiksaanwijzing - Nederlands - 17 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info