- 13 -- 12 -
Technical specifications
Installation instructions
Principle
GB
Dear Customer,
Congratulations on purchasing your new
STEINEL infrared sensor and thank you for the
confidence you have shown in us. You have
chosen a high-quality product that has been
manufactured, tested and packed with the
greatest care.
Please familiarise yourself with these instruc-
tions before attempting to install the unit. Be-
cause prolonged, reliable and trouble-free
operation will only be ensured if it is fitted and
used properly.
We hope your new infrared sensor will give you
lasting satisfaction.
The unit is equipped with pyro sensors that de-
tect the invisible heat emitted from moving ob-
jects (people, animals etc.). The heat detected
in this way is electronically converted into a
signal that switches ON a connected load
(e.g. a light). No heat radiation is detected
through obstacles, such as walls or panes of
glass, and will therefore not trigger the sensor.
Safety warnings
n This product must only be installed by a
qualified electrician in accordance with
national wiring regulations as defined in
VDE 08 29 (DIN EN 500090).
n Installed improperly, low-voltage products
can cause extremely serious personal injury
or damage to property.
n This product must never be connected to a
230 V AC power supply as it is intended for
connection to an extra-low voltage power
supply.
Operation
Note: To calibrate the product, please go to
www.knx.steinel.de
1. Issue physical address and generate
calibration programme in the ETS.
2. Load the physical address and calibration
programme into the presence detector.
When you are prompted, press the
programming button .
3. The red LED goes out once programming
has been successfully completed.
System components
Surface-mounting adapter
Sealing plug
Film shroud
Lens enclosure
Condensation water drainage hole
Wall mount / sensor unit
Corner wall mount (optional)
Plug-in terminals
Locking screw
Reach setting
Connect KNX bus
Programming button
Power supply lead, surface-mounted
Power supply lead, concealed
I
Dimensions (H x W x D): 114 x 74 x 128 mm
Power supply: KNX bus voltage
Angle of coverage: 300° with 180° angle of aperture, as well as sneak-by guard
for coverage directly below the sensor. Capability of masking
out individual segments
Reach: Adjustable in 3 directions independently of
each other by control dial, (2-20 m tangentially,
temperature-stabilised)
Sensor system: 4 sensors, 6 levels for long-distance detection and
5 for sneak-by guard,
1360 switching zones
Recommended
installation height: 2.00 - 2.50 m
Time setting: 1 min. - 15 min.
Manual override: selectable (4 hrs.) / (by remote control only)
Permanently OFF: selectable (6 hrs.) / (by remote control only)
IP rating: IP 54
Protection class: II
Temperature range: - 20 °C to + 50 °C
Electrical installation/Automatic mode
In selecting the wiring leads, it is important to
meet the wiring regulations laid down in VDE
08 29 (DIN EN 500090) - (see Safety warnings
on page 12).
II
GB
