1. Important! Disconnect
tool from power supply.
2. Undo screws and detach
cover cap .
3. Release cable grip .
4. Undo mains terminals .
5. Pull out cable .
6. Insert new cable and
secure in reverse order
(first tighten mains termi-
nals, etc.).
Changing Heating Element
The plug-in HG 4000 E/
HG 5000 E heating element
can be changed/replaced
within seconds.
Each heating element con-
tains a chip that holds its
specific data. When a new
heating element is installed,
its parameters will be
1. Important! Disconnect
tool from power supply.
2. Undo the 4 screws at the
end of the outlet nozzle.
3. Pull off heating element
and replace with new one.
4. Firmly re-secure output
nozzle.
adopted by the control elec-
tronics.
Changing Power Cord
Accessories / Example Applications
Accessories for HG 4000 E
40 x 2 offset flat nozzle
Applications: Plastic sheet
welding using the lap weld
process. Repair work on
bitumen roofs.
20 x 2 offset flat nozzle
Applications: Plastic sheet
welding using the lap weld
process.
5 mm round nozzle
Applications: Plastics
welding. Spot heating.
10 mm round nozzle
Applications: Plastics
welding. Spot heating. Use
with welding nozzle.
Welding nozzle
Applications: Pushes onto
10 mm round nozzle.
Welding with plastic welding
wire.
Accessories for HG 5000 E
70 x 10 flat nozzle
Applications: For concen-
trating air flow.
74 x 3 offset flat nozzle
Applications: Plastic sheet
welding using the lap weld
process.
If the power cord becomes
damaged it can be changed/
replaced easily without
opening the housing.
b
c
a
b
c
d
a
d
12 13
GB