593119
8
Verklein
Vergroot
Pagina terug
1/33
Pagina verder
Permanent light function
If a power switch is installed
in the supply lead, the
following functions are
possible in addition to simply
switching ON and OFF:
Sensor operation
1) Switch on the light:
Switch 1 x OFF and ON
The light remains on for the
set time.
2) Switch off light:
Switch 1 x OFF and ON
The light goes out or
transfers to sensor operation.
Permanent light operation
1) Switch on the light:
Switch 2 x OFF and ON
The light is set to permanent
illumination for 4 hours (the
red LED illuminates behind
the lens).
It subsequently changes
automatically to sensor oper-
ation (red LED goes out).
2) Switch off light:
Switch 1 x OFF and ON
The light goes out or changes
to sensor operation.
Reach setting/adjustment
Assuming an installation
height of 2.5 m, the maximum
reach of the sensor is 12 m.
Optimum adjustment of the
detection zone is possible
according to needs. The
shrouds provided serve to
cover any desired number of
lens segments and individu-
ally reduce the reach. False
switching by cars and
Important:
The switch should be
operated repeatedly in short
succession (in the range of
0.5 – 1 sec.)
pedestrians, etc. is therefore
ruled out, or risk areas
deliberately monitored.The
shrouds can be divided
vertically or horizontally along
the grooved divisions, or cut
with scissors 3. After
removing the decorative ring
4, the shrouds are to be
suspended on the upper part
of the sensor lens.
The decorative ring is
subsequently to be reapplied
and the shrouds are fixed
firmly in place.
Fine adjustment is also
possible by turning the
sensor housing by ± 60° 5.
5 sec. - 15 min.
max. 4 hours
1 x OFF/ON
2 x OFF/ON
Functions
Once you have installed the
housing and connected the
CeilingSensorLight, it can be
Twilight setting
(threshold)
ee
ee
e
Continuously adjustable
sensor response threshold
from 2 – 2000 lux.
Adjustment control set to 1
= daylight operation, approx.
2000 lux. (factory setting)
Adjustment control set to 6
= night-time operation
approx. 2 lux.
The adjustment control must
be set to 1 (daylight
operation) when setting the
detection zone in daylight.
Switch-off delay
(time setting)
ff
ff
f
Continuously adjustable light
duration of 5 sec. to 15 min.
Adjustment control set to 1
= shortest time
(5 sec., factory setting)
Adjustment control set to 6
= longest time (15 min.)
When setting the detection
zone, it is recommended to
select the shortest time
(setting 1).
Brightness control
(Watt-o-matic)
gg
gg
g
Continuously adjustable con-
stant light from 0 – 50 %.
When movement is detected,
the light switches from, say,
20 watts maintained light
output to maximum output
(100 watts).
Adjustment control set to 1
= no dimming (factory setting)
Adjustment control set to 6
= greatest dimming
If this control is rotated, the
red LED (behind the lens)
flashes and the light illumin-
ates with the set brightness.
After release, the dimming
level can be further adjusted
for approx. 3 sec. (LED con-
tinues to flash).
Soft light illumination
The CeilingSensorLight has a
soft light illumination function.
This means that the light
does not switch directly to full
put into operation. After remo-
ving the decorative ring d,
the adjusting screws for
twilight, time and brightness
control are visible.
output when switched on, but
the brightness is slowly incre-
ased to 100% within two
seconds. The electronics
operate equally gently when
switching off.
2 - 2000 lux approx. 5 sec. - 15 min. 0-50 %
1514
GB
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Steinel DL 750 S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Steinel DL 750 S in de taal/talen: Alle talen als bijlage per email.

De handleiding is 3,69 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info