c) Slide the display console neck onto the neck brackets of the
bike frame. CAUTION: Be careful not to pinch the wires or your
fingers between the console neck and the bike frame when sliding
the console into place.
d) Secure the display console to the frame with four M8 X 20
Button Head screws (two screws in front side and two screws in
back side). Using the 4mm hex wrench, tighten all four screws
securely.
e) Take the front display to the bike. Attach the cables from the
neck to the front display.
NOTE: If you are installing STAR TRAC Entertainment, Refer to the
PVS Install guide before you perform this step. If not take the Coax
and the DC Power cables and return them back down the neck.
f) Attach front display to back by sliding the bottom of the front dis-
play under the two tabs at the base of the round bar. Press the
display against the round bar and rotate it to the back. Be careful
not to pinch any wires.
g) Secure the front display to the back with (8) m4 x 0.7 x 19mm
long Phillips Head Screws. Us a #2 Phillips head screwdriver and
tighten the screws snug to the plastic.
STAR TRAC E SERIES BIKES OWNER’S GUIDE
17
1) Plug in the 12 pin display cable from the neck into
the front display circut board at J4.
2) Plug in the Heart Rate cable from the handlebars
into the HR board.
3) Plug the HR ground into the quick disconnect tab on
the display frame.
