4. Remove the water tank (6) by holding it by the handle and pulling it
up. Screw off the water tank lid (7) and fill the water tank with clean,
cold tap water up to the maximum mark. Make sure that the anticalc
cartridge (8) has been soaked in water for 24 hours prior (see “Before
setup“). Finally, screw the lid (7) back on the water tank (6). Then place
the water tank (6) in the unit. The water tray (9) will now slowly fill from
the water tank. Important: please do not move the appliance when it is
filled with water. The water could run into the electronics.
5. Press the on/off button (10) to switch Eva on. The current relative humid-
ity in % is shown on the display (15). If the water level indicator light (16)
is red, there is too little water in the unit. The humidification output level
is pre-set to level 3 and the desired humidity at 45 %.
6. Activate the Remote Sensor
TM
(2) by pressing the “Hygrostat” button
(11a). The humidity sensor automatically sends information about the
measured relative humidity several times per minute to the unit, which
shows it on the display (15). The measurement can also be activated by
pressing any button on the Remote Sensor
TM
(2) (aside from the on/off
button (10)).
7. The desired humidity can be changed by pressing the “Hygrostat” but-
ton (11) several times (35 – 75 % and continuous operation “CO”). The
symbol on the display (15) blinks during input. After a few seconds with-
out input, the selected value is saved. The symbol changes to the current
measured humidity.
Info: Once the desired air humidity is reached, the appliance stops and
the display blinks. Should the measured current air humidity fall below
the set value, the appliance begins to humidify again.
8. The humidification performance can be changed by pressing the “Out-
put” button (12) several times (levels 1 – 5). The level is indicated on the
display (15) by horizontal bars (e.g. 1 bar = level 1).
9. By pressing the “Warm” button (13), the warm mode, and with it the
water pre-heating, is turned on. Now the LED on the “Warm” button
on the unit is on. The heating plate (17) warms the water before it is
turned to mist by the ultrasonic membrane (19). The warm mode creates
a pleasantly warm mist plus increases the humidification performance.
10. By pressing the “Auto” button (14), the auto mode, and with it the Adap-
tive Humidity
TM
Technology, is activated. Now the LED on the “Auto”
button on the unit is on. In auto mode, the unit adapts the humidification
output level automatically in order to reach and maintain the desired
humidity of 45 % quietly and in an energy-efficient way. The lower the
current humidity is, the higher the humidification output level will auto-
matically be set (under 33 % = level 4, from 34 % – 37 % = level 3, from
38 % – 41 % = level 2, from 42 % – 45 % = level 1). You can change the
desired humidity in auto mode by pressing the “Hygrostat” button (11)
several times while auto mode is active (the LED on the “Auto” button
on the unit is on). The humidification output level (12) cannot be altered
manually in auto mode. As soon as the “Output” button (12) is pressed
to change the humidification output level, the auto mode is deactivated.
11. You can use Eva to disperse fragrances in the room. Be extremely spar-
ing with fragrances because an excessive dosage can result in the mal-
functioning of, and damage to, the appliance. In order to use fragrances,
briefly press and release the fragrance container (20) and pull it out of
the appliance. Let the fragrance drip directly onto the cotton pad in the
