16 Relaxxnow
2) Install the propeller
When installing the propeller, please use the wedge screw on the back of the
clamp of the propeller and connect to the bolt of the output shaft of the motor.
Then tighten the mounting nut of the propeller in an anticlockwise direction.
3) Put the front cover together
Insert the circle of the front cover into the screw of the cover ring which is
attached to the rear cover. Finally, tighten the screw into the ring joint.
INSTRUCTIONS
1. Adjust the wind direction
This fan can move up and down. The angle can be adjusted up or down by gently
lifting or pushing the cover.
2. Adjust the rotation
To control the rotation of the fan, press the knob on the head of the fan to start the
rotation of the fan and then pull it up to stop the rotation.
3. Adjustment of wind speed and wind type
Pressing the wind speed button will adjust the wind speed.
Simple troubleshooting
the propeller does not work when the starting the fan then please check if the mains plug is really
plugged into the socket or if the cover is warped and touching the propeller.
If you hear a noise when starting the fan, check for the following
Points:
(1) Propeller is securely installed in the output shaft of the engine.
(2) The groove on the back of the cover matches the insertion groove on the output shaft, i.e. the
grooves must line up.
(3) There is a small broken edge ring around the propeller.
(4) The cover has warped and is in contact with the propeller.
