585083

SpinMaster Hyper Actives Stunt - Air Hogs Handleiding

2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly.
• If at any time in the future you should need to dispose of this product please note
that Waste Electrical Products should NOT be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for
recycling advice. (Waste Electrical and Electronic Equipment Directive).
Warning:
CHOKING HAZARD –
Small Parts.
Air Hogs
®
, related trademarks & © 2011 Spin Master Ltd. All rights reserved. This
product conforms to safety requirements of ASTM F-963, EN-71 & CHPA. • Please retain
this information for future reference. • Please remove all packaging materials before
giving to children. • An adult should periodically check this toy to ensure no damage
or hazards exist, if so, remove from use. • Children should be supervised during play.
• Keep addresses and phone numbers for future reference. • The item inside this
package may vary from the photographs and/or illustrations. MADE IN CHINA.
20037619, 20037620 GEN REV 0
T20416_0002_20037619_GEN_IS_R1
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Customer Care: 1-800-622-8339 Fax: 416-364-8005
Email: customercare@spinmaster.com
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,
NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
SPIN MASTER INTERNATIONAL, S.A.R.L., 16 AVENUE PASTEUR, L-2310, LUXEMBOURG
www.spinmaster.com
TROUBLESHOOTING GUIDE
Vehicle is slow or will not move.
Vehicle does not drive in a
straight line.
My vehicle and/or controller is dirty.
Vehicle is not responding or driving
on it’s own.
1. Batteries in the controller need to be
replaced if green power light is flashing.
2. Vehicle is out of range of controller.
3. There is hair or debris stuck in the wheels
or wheel axles.
4. Batteries are installed incorrectly.
5. Improper surface for vehicle.
6. Controller not aimed at vehicle or
objects interfering with signal.
7. Controller was inactive for 30 seconds
or more and turned itself off to preserve
your batteries.
Vehicle requires wheel alignment.
1. Inappropriate driving surface.
2. Dirty hands.
1. Using another vehicle controller/
charger of the same frequency.
2. Infrared interference from another source.
3. Bright lights may be affecting the
IR control.
1. Replace batteries in the controller with new, fresh batteries.
2. Move closer to the vehicle.
3. With the vehicle and controller turned off, have an adult carefully remove the hair
or debris from the wheels or wheel axles.
4. With the vehicle and controller turned off, have an adult check that the batteries
are installed correctly in the controller.
5. Indoor play only on hard surfaces. Examples of poor play surfaces are thick
carpet, grass or sand. Examples of good play surfaces are non-carpeted floors,
flat tile floors or flat wooden floors.
6. Point controller IR at the vehicle. Ensure there are no objects blocking the
controller “line of sight” to the vehicle.
7. Re-set both vehicle and controller OFF to ON.
Refer to Trim Adjustment guide above.
Ensure the controller and vehicle are off. Have an adult remove the
batteries first and replace the battery cover. Slightly dampen a clean cloth in water
and wipe toy clean. Wipe dry. DO NOT IMMERSE IN WATER and DO NOT USE
ANY CHEMICALS. Let the toy completely dry before putting batteries back into
clean, dry battery compartment.
1. Only use the controller/charger supplied with this vehicle.
2. Do not operate vehicle around devices that emit other infrared signals.
3. Avoid driving near windows or bright lights or choose another place to operate
the vehicle.
PROBLEM CAUSE
SOLUTION
NOTE: If normal function of the product is disturbed or interrupted, strong
electro-magnetic interference may be causing the issue. To reset product, turn it
completely off, then turn it back on. If normal operation does not resume, move the
product to another location and try again. To ensure normal performance, change
the batteries, as low batteries may not allow full function.
Your Hyper Actives Stunt™ is equipped with a Lithium Polymer battery.
SPECIAL LIPO BATTERY INSTRUCTIONS:
• Never charge battery unattended. • Charge battery in isolated area. Keep away from
flammable materials. • Do not expose to direct sunlight. • There is a risk of the batteries
exploding, overheating, or igniting. Do not disassemble, modify heat, or short-circuit the
batteries. Do not place them in fires or leave them in hot places. • Do not drop or subject to
strong impacts. • Do not allow the batteries to get wet. • Only charge the batteries with the
specified Spin Master™ battery charger. • Only use the batteries in the device specified by
Spin Master™. • Carefully read the instruction guide, and use the batteries correctly. • In the
unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery.
• Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory installed, product disassembly
and battery removal must be performed by an adult. Do not use any tools for disassembly. Pulling, tearing,
and deforming of the product during disassembly, while necessary, should be as limited as possible. Do not
compress the product at any time. Ensure product is turned off. Find a point where the two body halves
meet; the front or back or sides of the vehicle. Start to peel the halves apart, separating them where they are
glued together; remove any tape as necessary. Separate product body halves to expose internal electronics.
To separate battery from product use scissors to cut a single battery wire, immediately wrap the cut wire
end with tape to isolate it, repeat until all battery wires are cut and isolated. Dispose of battery in accordance
with your local battery recycling or disposal laws. NOTE: Opening of product and/or removal of battery will
render product inoperative and voids manufacturer warranties, dispose of remaining product components in
accordance with local laws.
VEHICLE TRIM ADJUSTMENT
PERFORMING SPINS
ONCE YOU’RE FINISHED PLAYING
If the vehicle is not driving
straight when you push the
forward/reverse stick forward,
use the trim knob to correct
the problem.
1. If the vehicle turns to the left,
slowly turn the trim knob to
the right until the vehicle
drives straight.
2. If the vehicle turns to the
right, slowly turn the trim knob
to the left until the vehicle
drives straight.
Pressing the spin button while the
vehicle is moving/accelerating causes
the vehicle to spin. In some cases,
depending in speed, direction and
surface condition the vehicle may flip
over. Because the vehicle can run on
either side you can just keep driving.
CHG OFF ON
TURBO ACCELERATION
Pressing the turbo
button increases
the speed of the
vehicle.
1
2
Turn vehicle OFF.
Turn controller/charger OFF.
TM
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference to radio communications. Because this toy generates, uses, and can radiate radio frequency energy, there can be no guarantee that
interference will not occur. If not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If this toy does cause interference to radio or television reception (you can
check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy
and the radio or the TV • Consult the dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component
(crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the user’s authority to operate the equipment.
CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw SpinMaster Hyper Actives Stunt - Air Hogs bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van SpinMaster Hyper Actives Stunt - Air Hogs in de taal/talen: Engels als bijlage per email.

De handleiding is 2,01 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info