GB 12
4. CLEANING AND CARE
The ebios-fire furniture may only be cleaned when cold.
4.1 CLEANING CLADDING PARTS
• Wait until the device has cooled down before cleaning (at least 1 hour)!
• Decorative metal surfaces and the cladding parts can be cleaned with a
moist cloth (do not use a microfibre cloth!).
• Glass surfaces can be cleaned with a standard glass cleaner and a soft
cloth (do not use a microfibre cloth!).
• Stainless steel surfaces can be cleaned with a standard stainless steel
cleaning agent. Only use in the direction of the finish!
Remove any dust on and below the ebios-fire furniture regularly as dust
particles can burn or char. This can cause dirt in the room and on the
furnishings where the fire is installed.
5. MAINTENANCE / TROUBLESHOOTING
• The wick and burner mat must be visually inspected at regular intervals.
The material can be easily damaged. As such, the burner mat should
not be folded, bent or similar. It is not permitted to change the burner
mat or wick.
• The burner mat must be replaced after approx. 800 service hours (corre-
sponds to a fuel throughput of around 400 l bioethanol). Please contact
your specialist dealer.
• Only use our original spare parts.
• The tank seal must be examined occasionally for cracks or brittleness
and should be replaced if necessary.
• Please contact your specialist dealer should you have any questions.
3.4 REFILLING THE BURNER
The burner must NOT be filled when warm or alight and must NOT be filled
via the burner channel! DANGER TO LIFE!
Minimum waiting time between extinguishing and refilling the burner = 1
hour!
Please also leave the protective panes which may still be hot on the device
during this time! Risk of burn injuries!
The burners are designed for the fuel to be burnt until all gone. If you only
wish to enjoy the flames for a short period of time, use a correspondingly
smaller amount of fuel. If you wish to take the burner out of operation
prematurely, place the cover on the burner with the aid of the grip stick.
3.5 TAKING OUT OF OPERATION SAFELY
If you wish to take the burner out of operation at an earlier stage than
normal, place the cover on the burner with the aid of the ‘cold hand’. Insert
the ‘cold hand’ to grip the cover plate and then cover this over the burner
channel.
