562180
1
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
Safety, Environmental and Setup Instructions
Use the device in dry indoor environments only.
Protect the device from humidity.
Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.
Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the
specifications on the rating plate.
Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
Disconnect device warning: Main plug is used as the connection, so it should always remain ready operate.
The mains plug is used as the disconnect device, the disconnect device shall remain readily operable.
A damaged mains cable or plug must immediately be replaced by an authorized service center.
In case of lightning, immediately disconnect the device from the mains supply.
Children should be supervised by parents when using the device.
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
Do not expose the device to direct sunlight or other heat sources.
Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
Do not cover the ventilation openings!
The ventilation should not be impeded by covering the ventilation openings with items, such as newspaper, table-cloths, curtains, etc.
It shall be not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the
apparatus.
The unit should not be exposed to direct sunlight, very high or low temperature, moisture, vibrations or placed in dusty environment.
Never attempt to insert wires, pins or other such objects into the vents or opening of the unit.
Install the device at a safe and vibration-free location.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer
center.
The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.
Only use mercury and cadmium-free batteries.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Used batteries are hazardous waste and NOT to be disposed of with the household waste!!! Return the batteries to your dealer or to
collection points in your community.
Keep batteries away from children. Children might swallow batteries. Contact a physician immediately if a battery was swallowed.
Check your batteries regularly to avoid battery leakage.
CAUTION
-
INVISIBLE LASER RADIATION
WHEN OPENING
THE COVER
OR
PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.
ENVIRONMENTAL PROTEC
TION
Do not dispose of this product with the normal household waste at the end
of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.
The materials are reusable according to their markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.
Please contact your local authorities for details about collection points.
WARNING
Risk of electric shock
Do not open
!
Caution: To reduce the risk of electric shock, do not remove the cover (or back). There
are no user serviceable parts inside. Refer servicing to qualified service personnel.
Used batteries are hazardous waste and NOT to be disposed
of with the household waste! As a consumer you are legally
obligated to return all batteries for environmentally responsible
recycling – no matter whether or not the batteries contain harmful
substances*).
Return batteries
free of charge
to public collection points in your
community or to shops selling batteries of the respective kind.
Only return fully discharged batteries.
*) marked Cd = cadmium, Hg = mercury, Pb = lead
RCD5000 English Instruction Manual
1
LOCATION OF CONTROLS
1
Speaker
13
BAND Switch
2
Antenna
14
BASS Button
3
FOLDER DOWN Button
15
CD Compartment
4
FOLDER UP Button
16
LCD Button
5
MODE Button
17
CD Door Open Button
6
SKIP DOWN Button
18
AUX-IN Jack
7
SKIP UP Button
19
Battery Compartment
8
STOP/USB Button
20
AC Socket
9
PLAY/PAUSE Button
21
Handle
10
VOLUME Control
22
USB Slot (1A Charging)
11
TUNING Control
23
USB Slot (Decoding)
12
FUNCTION Switch
24
NFC Sensor
AC OPERATION
Before operation, please make sure that the VOLTAGE mentioned on the unit is same as the voltage of your local
area. Unravel the AC power cord, insert one end into the AC socket on the set, and the other end into a standard
AC outlet.
ATTENTION
1. Do not plug or unplug the power cable while you have wet hands.
2. When planning not to use this unit for a long time, disconnect the power cable from the wall outlet.
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in order to avoid shock risks
caused by damaged cable.
BATTERY OPERATION
Disconnect the AC cord set completely. Open the battery compartment door and insert 8 pieces UM-2 "C" size
batteries into the battery compartment with battery polarity as shown inside the battery compartment.
USB CHARGING (1 A)
This product can provide 1A charging when it is under AC operation. You can charge most of the smartphones and
tablets. Please be reminded to connect your device to the correct USB slot.
BASS EFFECT
Press BASS button for bass effect.
RADIO OPERATION
1. Set the FUNCTION switch to RADIO position.
2. Rotate the TUNING control to tune to your desired radio station.
3. Adjust the sound level by rotating the VOLUME control.
4. To turn off the radio, set the FUNCTION switch to OFF position.
FM Stereo/Mono Broadcast
For FM Mono Broadcast, set the BAND switch to FM.
For FM stereo broadcast, set the BAND switch to FM ST. "ST." will be shown on the display.
RCD5000 English Instruction Manual
2
ANTENNA
For best reception, fully extend the FM Antenna to receive FM stations.
MP3/AUX IN CONNECTION
1. Set the FUNCTION switch to BT/AUX position.
2. Insert one side of the audio cable (requires 3.5mm stereo plug, not supplied) into the line-out jack or phones
jack on your MP3 player and the other side to the aux-in jack on the unit.
3. Turn on your MP3 player and follow the playback instruction.
4. Adjust the sound level by rotating the VOLUME control.
5. To stop this function, simply turned off your MP3 player.
CD/MP3/USB OPERATION
Playing Audio CDs
1. Set the FUNCTION switch to CD/USB position.
2. Insert a CD disc in the CD compartment and close the CD door, the unit will start reading the disc and will play
automatically.
3. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the
PLAY/PAUSE button again.
4. Adjust the sound level by rotating the VOLUME control.
5. To stop playing the CD, press the STOP button.
Playing MP3 Discs
1. Set the FUNCTION switch to CD/USB position.
2. Insert a MP3 disc into the CD Compartment and close the door, the unit will start reading the disc and will play
automatically.
3. If your MP3 disc has folders, you can use the FOLDER DOWN/FOLDER UP button to select the desired folder.
4. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the
PLAY/PAUSE button again.
5. Adjust the sound level by rotating the VOLUME control.
6. To stop playing the CD, press the STOP button.
Playing MP3 files with USB device
1. Set the FUNCTION switch to CD/USB position.
2. Press and hold the STOP/USB button to select the USB mode, USB will appear on the LCD display.
3. Plug your USB device into the USB port on the unit, the unit will start reading the files in the USB device and
play automatically.
4. If your USB device has folders, you can use the FOLDER DOWN/FOLDER UP button to select the desired folder.
5. During playing, press the PLAY/PAUSE button to temporarily pause playing. To resume, press the
PLAY/PAUSE button again.
6. Adjust the sound level by rotating the VOLUME control.
7. To stop playing the files in the USB, press the STOP button.
Note:
Because of non-standardized format definition/production of MP3 format, playback quality & performance are not
guaranteed.
Manufacturer is not responsible for the playability of MP3 in any case due to recording conditions such as PC
performance, writing software, media ability and etc.
Different Play Mode
Press the MODE button to select different kinds of play mode with the following sequence.
For Audio CDs : Repeat 1 Repeat All Normal
For MP3 Files : Repeat 1 Repeat Folder Repeat All Normal
Repeat 1 – repeat the track being played.
Repeat All – repeat all the tracks in the storage media.
Repeat Folder – repeat the tracks in the entire folder.
Normal – play the tracks in sequence.
RCD5000 English Instruction Manual
3
Skip Mode
1. During play or pause mode, press the SKIP UP button to go to the next track.
2. During play or pause mode, press the SKIP DOWN button to go back to the previous track.
Programming
In case of Playing Audio CD/MP3 disc
The programming should be done during STOP mode
1. Press the MODE button, the LCD display will show P01.
2. Use the SKIP UP or SKIP DOWN button to select the desired track.
3. Press the MODE button again to store the selected track in the memory, the LCD display will show P02 and
flash continuously.
4. Repeat step 2 to 3 to store more tracks in the memory. You can store up to 20 tracks in the memory for CD disc
and 99 tracks in the memory for MP3 disc.
5. Press the PLAY/PAUSE button to start playing the disc in the programmed order.
6. To stop playing, press the STOP/USB button.
7. To cancel the programming list, press the STOP/USB button and set the FUNCTION switch to OFF position.
BLUETOOTH STREAMING
1. Set the FUNCTION switch to BT/AUX position. The LCD display will show “bt” and the bluetooth icon will flash.
2. Turn on your Bluetooth of your Bluetooth device and search the boombox for connection. Your Bluetooth device
should find “RCD5000”.
3. If the connection is successful, the bluetooth icon on the LCD display will stop flashing.
4. Select and play the audio files though your Bluetooth device.
5. To stop this function, switch to other mode or shut down your Bluetooth of your Bluetooth device
BLUETOOTH STREAMING THROUGH NFC PAIRING
1. Set the FUNCTION switch to BT/AUX position. The LCD display will show “bt” and the bluetooth icon will flash.
2. Enable your NFC function of your Bluetooth device and place the device near the NFC sensor on the CD door
for 5 to 10 seconds.
3. If the connection is successful, your Bluetooth device will show that it is connected and the bluetooth icon on
the LCD display will stop flashing.
4. Select and play the audio files though your Bluetooth device.
5. To stop this function, switch to other mode or shut down your Bluetooth of your Bluetooth device
AUTO PAIRING
Once the unit paired with the Bluetooth device, it will automatically pair with that device next time when you turn on
the unit and that Bluetooth device.
SPECIFICATIONS
Frequency Range: FM 87.5 - 108 MHz
Power Supply: AC 100-240V ~ 50/60Hz
DC 12V (UM-2 x 8)
Specifications are subject to change without further notice.
IMPORTANT NOTICE
Automatic standby mode
To comply with the ErP2 directive, the unit automatically switches to standby after approx. 11 minutes without a signal.
(For instance in CD-Stop mode). To switch the unit on again, please follow the instructions mentioned in instruction
manual.
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Soundmaster RCD5000 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Soundmaster RCD5000 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,54 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Andere handleiding(en) van Soundmaster RCD5000

Soundmaster RCD5000 Gebruiksaanwijzing - Nederlands, Deutsch - 38 pagina's

Soundmaster RCD5000 Gebruiksaanwijzing - Deutsch - 6 pagina's

Soundmaster RCD5000 Gebruiksaanwijzing - English, Français, Português, Espanõl, Svenska, Norsk, Suomi - 38 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info