611473
18
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
16 Soundcraft MFXi MPMi User Guide Issue 1210
WIRING UP
Mic Input
The MIC input accepts XLR-type connectors and is designed to suit a wide
range of BALANCED or UNBALANCED low-level signals, whether from
delicate vocals requiring the best low-noise performance, or drum kits
needing maximum headroom. Professional dynamic, condenser or ribbon
mics are best because these will be LOW IMPEDANCE. While you can
use low-cost HIGH IMPEDANCE mics, you do not get the same degree of
immunity to interference on the microphone cable and as a result the level
of background noise may be higher. If you turn the PHANTOM POWER on,
the socket provides a suitable powering voltage for professional condenser
mics.
The input level is set using the input GAIN knob.
The LINE input offers the same gain range as the MIC input, but at a higher
input impedance, and is 15dB less sensitive. This is suitable for most line
level sources.
Line Input
Accepts 3-pole 6.35mm (1/4”) jacks, or 2-pole mono jacks which will auto-
matically ground the ‘cold’ input. Use this input for sources other than mics,
such as keyboards, drum machines, synths, tape machines or DI boxes. The
input is BALANCED for low noise and immunity from interference, but you
can use UNBALANCED sources by wiring up the jacks as shown, although
you should then keep cable lengths as short as possible to minimise inter-
ference pick-up on the cable. Note that the ring must be grounded if the
source is unbalanced. Set the input level using the GAIN knob, starting with
the knob turned fully anticlockwise. Unplug any MIC connection when using
the LINE input.
Insert Point
The unbalanced, pre-EQ insert point is a break in the channel signal path,
allowing limiters, compressors, special EQ or other signal processing units
to be added in the signal path. The Insert is a 3-pole 6.35mm (1/4”) jack
socket which is normally bypassed. When a jack is inserted, the signal path
is broken, just before the EQ section.
The signal from the channel appears on the TIP of the plug and is returned
on the RING, with the sleeve as a common ground.
The Send may be tapped off as an alternative pre-fade, pre-EQ direct output
if required, using a lead with tip and ring shorted together so that the signal
path is not interrupted.
WARNING !
Start with the input GAIN knob turned fully anticlockwise
when plugging high level sources into the LINE input to avoid
overloading the input channel or giving you a very loud surprise!
DO NOT use UNBALANCED sources with the phantom power
switched on. The voltage on pins 2 & 3 of the XLR connector may
cause serious damage. BALANCED dynamic mics may normally be
used with phantom power switched on (contact your microphone
manufacturer for guidance)
18

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Soundcraft-MFXi

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Soundcraft MFXi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Soundcraft MFXi in de taal/talen: Engels als bijlage per email.

De handleiding is 2,32 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Soundcraft MFXi

Soundcraft MFXi Gebruiksaanwijzing - Deutsch - 47 pagina's

Soundcraft MFXi Gebruiksaanwijzing - Français - 56 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info