611447
14
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
USER GUIDE
12
WIRING UP
Please refer to pages 35/36 for additional wiring details.
MIC INPUT
The mic input accepts XLR-type connectors and is designed to suit a wide range of BALANCED or
UNBALANCED low-level signals, whether from delicate vocals requiring the best low-noise performance or
close-miked drum kits needing maximum headroom. Professional dynamic, condenser or ribbon mics are
best because these will be LOW IMPEDANCE. While you can use low-cost HIGH IMPEDANCE mics, you do
not get the same degree of immunity to interference on the microphone cable and as a result the level of
background noise may be higher. If you turn the PHANTOM POWER on, the socket provides a suitable pow-
ering voltage for professional condenser mics.
The input level is set using the input GAIN knob.
The LINE input offers the same gain range as the MIC input, but at a higher input impedance, and is 20dB
less sensitive. This is suitable for most line level sources
LINE INPUT
Accepts 3-pole `A gauge jacks, or 2-pole mono jacks which will automatically ground the ‘cold’ input. Use
this input for sources other than mics, such as keyboards, drum machines, synths, tape machines or guitars.
The input is BALANCED for low noise and immunity from interference, but you can use UNBALANCED sourc-
es by wiring up the jacks as shown, although you should then keep cable lengths as short as possible to
minimise interference pick-up on the cable. Note that the ring must be grounded if the source is unbal-
anced. Set the input level using the GAIN knob, starting with the knob turned fully anticlockwise. Unplug
any MIC connection when using the LINE input.
INSERT POINT
The unbalanced, pre-EQ insert point is a break in the channel signal path, allowing limiters, compressors,
special EQ or other signal processing units to be added in the signal path. The Insert is a 3-pole A gauge
jack socket which is normally bypassed. When a jack is inserted, the signal path is broken, just before the
EQ section.
The signal from the channel appears on the TIP of the plug and is returned on the RING, with the sleeve as
a common ground.
The Send may be tapped off as an alternative pre-fade, pre-EQ direct output if required, using a lead with
tip and ring shorted together so that the signal path is not interrupted.
DO NOT use UNBALANCED sources with the phantom power switched on. The voltage
on pins 2 & 3 of the XLR connector may cause serious damage. BALANCED dynamic
mics may normally be used with phantom power switched on (contact your
microphone manufacturer for guidance)
WARNING ! Start with the input GAIN knob turned fully anticlockwise when plugging
high level sources into the LINE input to avoid overloading the input channel or giving
you a very loud surprise!
14

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Soundcraft M12 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Soundcraft M12 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Soundcraft M12

Soundcraft M12 Gebruiksaanwijzing - Deutsch - 44 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info