812335
20
Verklein
Vergroot
Pagina terug
1/24
Pagina verder
Room Controller
This value is used to appoint the amount of influence the room temperature has on the reference flow temperature, as a per-
centage. For every degree of the room temperature deviates from the reference room temperature, the percentage of the cal-
culated reference flow temperature set here is added to or subtracted from the reference flow temperature, so long as it is within
the limits of the min. and max. flow temperatures that can be set in the protective functions.
Example: Reference room temp.: e.g. 25 °C; room temp.: e.g. 20 °C ±5 °C. Calculated reference temp.: e.g. 40 °C: room con-
troller: 10 %= 4 °C 5 X 4 °C= 20 °C. Accordingly, 20 °C are added to the reference flow temperature, giving 60 °C. If the value is
higher than the one set in max. flow temp, the resulting temperature is the one set in max. flow temp.
Room Reference (Day)
The desired room temperature for day mode. As long as this temperature is not reached, the reference flow temperature is raised
and/or lowered according to the percent setting in ‚room controller‘. If ‚room controller‘ is set to 0 %, this function is deactivated.
Room Reference (Night)
The desired room temperature for night mode. As long as this temperature is not reached, the reference flow temperature is
raised and/or lowered according to the percent setting in room controller‘. If ‚room controller‘ is set to 0 %, this function is deac-
tivated.
In the modes ‚Set point‘ and Set point program, the room controller has no influence.
Thermostat
The room controller is set here. If no RC21 is connected, a room controller from another heating controller over can be selected
over the CAN bus. The CAN bus ID of controller is shown in Menu 6, Service Data‘ under ‚CAN Bus ID‘. Choose the RC21 with
the CAN Bus ID of the corresponding controller. The heat controller now obtains the switch position and rotary switch position
from the CAN bus.
Eco Display Mode
In Eco Display Mode the backlight of the display is switched off if no buttons are pushed for 2 minutes.
If a message exists, the backlight does not switch off until the message has been scanned by the user.
Network
If applicable, the network settings of the connected data logger have to be adjusted
Access Control
This menu lets you give up to 4 users access to the data logger. The users that are registered then have access to the controller
or respectively the data logger.
To add a user in the list, select <add user>. Leave the now visible menu open und connect to the address of the connector or
respectively the data logger. Your user name is going to appear in this menu and can be selected and confirmed with ‘OK’.
Note
You can find the address of the connector or respectively the data logger on the address sticker on the outside of the casing.
Pointers and help on how to establish a connection you can find in the enclosed SOREL connect instructions or the instructions
of the data logger.
Select a user with ‘OK’ to grant access.
To revoke access again, choose one of the users from your list and choose <remove user>.
20
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sorel MHCC bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sorel MHCC in de taal/talen: Engels als bijlage per email.

De handleiding is 3.18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Sorel MHCC

Sorel MHCC Gebruiksaanwijzing - Deutsch - 24 pagina's

Sorel MHCC Gebruiksaanwijzing - Français - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info