812374
45
Verklein
Vergroot
Pagina terug
1/50
Pagina verder
Malfunctions/Maintenance
Replacing the Fuse
Repairs and maintenance may only be performed by a specialist. Before working on the unit, switch off the power supply and
secure it against being switched on again! Check that there is no power flowing!
Only use the supplied spare fuse or a fuse of the same design with the following specifications: 2 AT/250 V.
If the mains voltage is switched on and the controller still does not function or display anything,
then the internal device fuse may be defective. First find the external fault source (e.g. pump),
replace it and then check the device fuse.
To replace the device fuse, open the device as described under "See " wall Installation " on page
25", remove the old fuse, check it and replace if necessary.
Then first recommission the controller and check the function of the switch outputs in manual mode
as described in Section 3.2.. .
Maintenance
In the course of the general annual maintenance of your heating system, the functions of the controller should also checked by
a specialist and the settings should be optimized if necessary.
Performing maintenance:
lCheck the date and time See " Time & Date " on page 42
lAssess/check plausibility of statistics See " Statistics " on page 29
lCheck the error memory See " Message Log " on page 29
lVerify/check plausibility of the current measurement values See " Measurement values " on page 28
lCheck the switch outputs/consumers in manual mode See " Manual " on page 30
lPossible optimization of the parameters setting (only on customers request)
Possible error messages
Possible error messages Notes for the specialist
No flow If ΔT between store and collector is 50 ° C or more for 5 minutes, this message is displayed.
Frequent on / off A relay was switched on and off more than 5 times within 5 minutes.
AL failed Anti-legionella failed appears if at least anti-legionella Tsoll -5 °C could not be held at the anti-legion-
ella sensor for the set exposure time.
System protection The collector temperature has exceeded the set temperature and the solar pump has been turned
off, so that the system does not overheat.
Collector protection The collector temperature has exceeded the set temperature and the solar pump has been turned
on, in order to cool the collector via the storage.
Recooling The exceeding energy is/was transmitted via the collector to protect the system.
Frost Protection The solar pump is switched on in order to protect the collector from freezing.
Low system pressure It is displayed when Pmax pressure monitoring is active and Pmax is exceeded.
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sorel LTDC bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sorel LTDC in de taal/talen: Engels als bijlage per email.

De handleiding is 5.41 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Sorel LTDC

Sorel LTDC Gebruiksaanwijzing - Nederlands - 36 pagina's

Sorel LTDC Gebruiksaanwijzing - Deutsch - 50 pagina's

Sorel LTDC Gebruiksaanwijzing - Français - 36 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info