36116

Sony ICFM410V Handleiding

2
Verklein
Vergroot
Pagina terug
1/2
Pagina verder
Telescopic
Antenna
TUNE/TIME SET
VOL
DC IN 4.5V
v (earphone)
jack
Insert the # side of the battery first.
Rear
Size AA (R6) × 3
TV/WEATHER/FM AM
to a wall outlet
to DC IN 4.5V
AC power adaptor (not supplied)
Choosing Power Source
Installing Batteries (See fig. A)
1 Open the lid of the battery compartment at the rear of the unit.
2 Install three size AA (R6) batteries (not supplied) with correct polarity and then close the
lid.
“AM 12:00” flashes on the display when you first install the batteries. To stop the flashing, set the clock.
(See “Setting the Clock”)
Battery Life (Approx. hours) (JEITA*)
TV WEATHER FM AM
Sony alkaline size AA (LR6) batteries 28 28 29 41
Sony size AA (R6) batteries 16 16 17 24
* Measured by JEITA (Japan Electronics and Information Technology Industries Association) standards.
The actual battery life may vary depending on the circumstance of the unit.
When to replace the batteries
When the batteries become weak, the sound may become weak or distorted, and “E” will flash in the
display. After that, when the batteries are used up, “E” will light and the power of the unit will be turned
off. If this happens, replace the batteries with new ones.
After the batteries are replaced, press POWER to turn the indication off.
Note on replacing the batteries
Do not take more than 40 seconds to replace the batteries, otherwise the clock, standby settings and preset
stations will be initialized. Should that happen, reset the functions.
Notes on batteries
• Do not charge the dry batteries.
• Do not carry the dry batteries together with coins or other metallic objects. It can generate heat if the
positive and negative terminals of the batteries accidentally come into contact with metallic objects.
• When you are not going to use the unit for a long time, remove the batteries to avoid damage from
battery leakage and corrosion.
• Do not use different types of batteries at the same time.
• When you replace the batteries, replace all with new ones.
To attach the battery compartment lid if it is accidentally detached (See Fig.B)
1 Insert one side of the lid as illustrated.
2 Push the other side to attach.
Using House Current (See fig. C)
Connect the Sony AC power adaptor (not supplied) to the DC IN 4.5 V jack firmly, and plug it into a wall
outlet.
Notes on the AC power adaptor
• When operating the unit with an external power source, do not remove the batteries.
These batteries serve to backup settings stored to memory. Since batteries discharge in this case as well,
we recommend changing them about once a year.
• Before connecting and disconnecting the external power source plug, be sure to turn off the radio.
Otherwise, “E” may be displayed.
When this occurs, turn on the radio so that “E” disappears.
• When operating the unit with the internal batteries, remove the AC power adaptor from the wall outlet
and the DC IN 4.5 V jack. Make sure that the plug of the external power source is disconnected before
operating the unit.
• Use the recommended Sony AC power adaptor* only. The polarity of the plugs
of other manufacturers may be different. Failure to use the recommended AC
power adaptor may cause the unit to malfunction.
* For details on the optional AC power adaptor, see “Specifications”.
Preventing Accidental Change – HOLD function
Slide HOLD. “ - ” is displayed, indicating that all the functions of the buttons are locked.
To release the key protection, slide HOLD again so that “ - ” disappears.
Setting the Clock
The display will flash “AM 12:00” when the batteries are installed or the AC power adaptor is plugged in
for the first time.
1 To stop the display from flashing, press CLOCK when the radio is off.
2 While holding down CLOCK, turn TUNE/TIME SET to set the clock to the current time.
When you turn TUNE/TIME SET a little to or , the clock digits move forward or backward one by
one, and when you turn TUNE/TIME SET further to or , the clock digits move rapidly.
When you release CLOCK, the clock starts operating, and “:” starts flashing.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is factory-set to 10 kHz.
Change the settings as shown below to be able to listen to the radio.
Area Channel step
North and South American countries 10 kHz
Other countries/regions 9 kHz
Note
When the AM channel step is changed, the preset stations for AM will be initialized.
1 Press POWER to turn off the power.
2 While holding down CLOCK, keep pressing POWER for more than 5 seconds.
Two short beeps sound, and the AM channel step will be changed.
“9 kHz” (or “10 kHz”) is displayed for about 3 seconds.
If you proceed to step 2 again, the channel step changes again.
Playing the Radio – Manual Tuning
1 Press POWER to turn on the radio.
2 Press BAND repeatedly to select the band.
Each press changes the band as follows:
Each band memorizes the frequency you had tuned previously.
To change the band to WEATHER, press WEATHER. You can return to the previous frequency by
pressing BAND.
3 Turn TUNE/TIME SET.
When you turn TUNE/TIME SET a little to or , the frequency digits
move forward or backward one step at a time, and when you turn
TUNE/TIME SET further to
or , the frequency digits move rapidly.
4 Adjust the volume using VOL.
To turn off the radio
Press POWER again.
To listen with an earphone (not supplied)
Connect an earphone (not supplied) to the v jack. The sound through the speaker will not be heard.
Improving the Reception (See fig. D)
TV/WEATHER/FM: Extend the telescopic antenna and adjust the length and the angle for best reception.
AM: Rotate the unit horizontally for optimum reception. A ferrite bar antenna is built in the unit.
Note
Adjust the direction of the antenna, holding the bottom of it. The antenna can be
damaged when you move the antenna with excessive force.
Presetting Your Favorite Station – Preset Tuning
You can preset up to 5 stations in each TV, WEATHER, FM and AM.
Presetting a Station
1 Follow steps 1 to 4 in “Playing the Radio” and manually tune in to the station you wish to
preset.
2 Press the PRESET TUNING button you wish to preset for
more than a few seconds.
You will hear two confirmation beeps and preset number
appears in the display
To preset another station, repeat these steps.
To change the preset station, preset a new station. The previous
station will be cancelled.
Tuning in a Preset Station
1 Press POWER to turn on the radio.
2 Select the band with BAND or WEATHER.
3 Press the desired PRESET TUNING button.
4 Adjust the volume using VOL.
Note
Holding down the desired PRESET TUNING button for more than a few seconds will replace the previous
station on the PRESET TUNING button with the station you tuned in to.
Setting the Standby Timer
You can set the radio to turn on at a preset time.
You can set the standby timer whether or not the radio is turned on.
1 Hold down STANDBY until “ ” starts flashing.
2 While holding down STANDBY, turn TUNE/TIME SET to set the time for the radio to be
turned on.
3 When STANDBY is released, the standby timer is activated and “ ” stops flashing.
The radio is turned on and “ ” is displayed at the preset time. After 60 minutes, the radio will
automatically turn off.
Once you set the standby timer, the radio will turn on at the same time everyday.
Deactivating the standby timer
Press STANDBY so that “ ” disappears.
If holding down STANDBY for more than about a second, the standby timer is activated.
Setting the Sleep Timer
By setting the sleep timer, the radio turns off automatically after a set time
(60, 45, 30 or 15 minutes).
1 Press SLEEP.
The sleep timer setting of “60” is displayed and “ ” flashes.
If you press SLEEP while the radio is off, the radio turns on.
2 Press SLEEP repeatedly to select the desired sleep timer
setting while “ ” is flashing.
Each press changes the display as follows:
“ ” is displayed for about three seconds and the frequency is
displayed.
The sleep timer starts operating.
The radio will turn off automatically after the set time.
To cancel the sleep timer
Press POWER to turn off the radio before the set time has elapsed, and press POWER again to turn on the
radio.
To extend the time
Reset the sleep timer to a longer one.
A
B
C
D
Example: Display window
when you preset FM
90.0 MHz in preset
number 2.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sony ICFM410V bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sony ICFM410V in de taal/talen: Engels als bijlage per email.

De handleiding is 0,59 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info