680782
65
Verklein
Vergroot
Pagina terug
1/88
Pagina verder
65
S10931-00001_Rev-D_EN
13. Function test and final test
13.1 Testing obstacle detection
Observe in particular the following safety instructions for
this chapter.
After initial operation of the operator, the force
measurement of the operator must be checked with
a force measurement device and an obstacle detection
test must be performed.
WARNING
Danger due to projecting parts!
Door leaves or other parts must not
project into roads or public footpaths.
This also applies while the door is
moving.
This may cause serious injury or death
to persons or animals.
Keep public roads and footpaths clear
of projecting parts.
WARNING
Danger of entrapment!
If the force setting is too high, persons
or animals in the movement area of the
door may be trapped and pulled along
with the door. Severe injuries or death
may result.
The force setting is relevant to safety
and must be carried out by a qualied
specialist.
You must proceed with extreme caution
if you check and if necessary adjust
the force setting.
WARNING
Danger of crushing and shearing!
If the door moves and there are persons
or animals in the movement area,
crushing and shearing injuries may be
caused by the mechanism and safety
edges of the door.
Note that obstacle detection does not
operate below 50 mm.
The obstacle detection must be tested
once a month.
Only use the operator when you have
a direct view of the door.
All danger zones must be visible during
the entire door operation.
Always keep the moving door in sight.
Keep persons and animals clear of the
range of movement of the door.
Never put your hand near the door
when it is moving or near moving parts.
In particular, do not reach into the
moving push arm.
Do not reach into the ceiling suspension
unit when the motor carriage is running
along the track.
Do not drive through the door until it has
opened completely.
Never stand under the opened door.
NOTE
Observe the national standards, guidelines
and regulations for cut-off of the operating
forces.
NOTE
The obstacle detection must be tested
once a month to prevent damage to the
operator.
INFORMATION
After installation of the operator, the
person responsible for the installation
of the operator must complete an
EC Declaration of Conformity for
the door system in accordance with
Machinery Directive 2006/42/EC and
apply the CE mark and a type plate.
This documentation and the installation
and operating manual for the operator
must be handed over to the user.
This also applies if the operator is
retrotted to a manually operated door.
65

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sommer S 9080 pro bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sommer S 9080 pro in de taal/talen: Engels als bijlage per email.

De handleiding is 10,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Sommer S 9080 pro

Sommer S 9080 pro Gebruiksaanwijzing - Nederlands - 88 pagina's

Sommer S 9080 pro Gebruiksaanwijzing - Deutsch - 88 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info