680782
61
Verklein
Vergroot
Pagina terug
1/88
Pagina verder
61
S10931-00001_Rev-D_EN
11. Connections and special functions of the wall
control unit
11.10 Output OC
The door status display can be shown with the Output
OC (open collector output) accessory part. To do this,
set DIP switch 2 on the wall control unit to "ON."
P
AD
1
4
Fig. Relay slot for Output OC
The Output OC accessory part is plugged into the Relay
slot, see separate "Output OC" instructions.
11.11 Relay
External lighting such as the garage light, courtyard light
or door status display can be controlled with the relay
accessory part. The function depends on the setting of
the DIP switches. See also chapter "11.3 Setting the
DIP switches on the wall control unit."
P
AD
1
4
Fig. Relay slot
The Relay is plugged into the Relay slot on the wall
control unit, see separate "Relay" instructions. The
maximal switching capacity is 5 V, 250 V AC or 5 A,
24 V DC.
11.12 Installing and removing the
accumulator
The accumulator can bridge approximately 5 cycles
within 12 hours in the event of a power failure. Only
a qualified electrician is permitted to install, test and
replace the accumulator. See Chapter "7.1 Cover of the
motor carriage." Follow the instructions in the separate
installation and operating manual for the accumulator.
NOTE
If an accumulator has been installed,
it is connected to the circuit board.
Carefully remove the control unit cover
and disconnect the connections to prevent
damage to the wall control unit.
INFORMATION
Only an original accumulator from
SOMMER may be used.
INFORMATION
Initial operation is not supported if the
accumulator is the sole power supply.
Mains voltage is required for initial
operation of the operator.
INFORMATION
The accumulator can only be recharged for
a limited number of cycles. This depends
on the use and settings.
Installing the accumulator
Fig. 1
1. Disconnect the operator from the mains voltage.
Check that the operator is disconnected from the
power supply.
2. Unscrew the light cover from the wall control unit and
remove it upwards. Hold the front control unit cover
firmly while doing so, see chapter "7.3 Light and
control unit cover of the wall control unit."
3. Remove the control unit cover gently towards
the front and unplug the connection cable for the
membrane keypad from the wall control unit.
Fig. 4
4. Place the accumulator in the control unit cover and
fasten with two cable binders.
61

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Sommer S 9080 pro bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Sommer S 9080 pro in de taal/talen: Engels als bijlage per email.

De handleiding is 10,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Sommer S 9080 pro

Sommer S 9080 pro Gebruiksaanwijzing - Nederlands - 88 pagina's

Sommer S 9080 pro Gebruiksaanwijzing - Deutsch - 88 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info