How to install the navigation box to your
vehicle:
1. Plug the Map SD card into the navigation box.
2. Connect port “DC IN” (Navigation Box) with
power cable; on power cable, ACC to Car ACC,
BAT to Car battery, GND to ground, and MUTE to
mute wire from monitor.
Note: please DON’T connect BAT and ACC
together.
3. Connect GPS antenna, and put it where you can
receive GPS signal well.
4. Link RGB (9 pin) cable, Data (8 pin) or AV cable to your monitor and use USB
mouse to select the right panel.
Note: on RGB cable, you could see PIN 1 and PIN 2,
PIN 1=external navigation mute
PIN 2=rear camera trigger
5. If you have touch screen, connect 4-pin touch cable to the 4-pin hole on the side of
navigation box.