EN • 6
see the blue LED visual alert and the laser receiver has a clear, unobstructed
view of the road ahead. Laser Pod can be mounted with the blue LED visual
alert positioned above or below the mirror as per the photographs below. If
this is possible, mount your Laser Pod using the double sided pads provided.
Remove one side of the double sided pad and attach the pad to the front of
your Laser Pad. Next remove the other side of the double sided pad and then
put Laser Pod into position. Press and hold until your Laser pod is firmly in
place.
Finally connect the USB plug on the end of the car charger to the DC 5V IN
socket on the Laser Pod and plug the other end into the cigarette lighter
socket of your vehicle. Laser Pod will power on automatically, the blue LED will
flash and the unit will beep three times. Your Laser Pod is now ready to use.
Direct connecting/hard wiring your Laser Pod
You can power your Laser Pod by wiring it directly to your vehicles 12V
electrical system using a ‘Hard Wire’ cable which can be purchased from your
Snooper dealer. First connect the positive side of the cable (marked with
a red plus symbol) to a 12V switched live. This is a live that is ON when the
ignition is ON and OFF when the ignition is OFF. The negative side of the lead
should be connected to a negative ground, so it can be attached to any metal
portion of the vehicles frame. Next plug the small adaptor on the other end
of the lead into the DC 5V In socket on the Laser Pod.
Important: If you are unfamiliar with this procedure, please consult a
professional auto electrician.
