77706
8
Verklein
Vergroot
Pagina terug
1/14
Pagina verder
Instructions for the Installer
24
5. ADAPTING TO DIFFERENT TYPES OF GAS
Before carrying out the operations described below, disconnect the appliance from the
electricity supply.
The appliance is tested with G20 (2H) natural gas at the pressure of 20 mbar. If it is to be used with other
types of gas, the burner nozzle has to be changed and the gas valve adjusted. To replace the nozzle,
proceed as described below.
5.1 Adjusting the oven burner
To adjust the oven burner, open the oven door and proceed as follows:
remove all accessories (pans, shelves and any steel runners);
lift the oven bottom plate and extract it so that the inside of the oven
is as shown in the picture.
5.1.1 Adjusting the minimum setting (models with slotted front panel)
The oven thermostat has a screw for regulating the minimum setting,
visible from the 18th slot of the front panel, starting from the right.
When the type of gas used changes, the by-pass must be replaced as
follows:
Remove the top case unscrewing the respective screws.
Unscrew the by-pass with a straight-head screwdriver and extract it
from its housing with pliers.
Fit the by-pass (supplied) tightening the screw fully
5.1.2 Adjusting the minimum setting (models without slots on front panel)
The oven thermostat has a screw for regulating the minimum setting,
accessed by removing the thermostat knob. When the type of gas used
changes, the minimum setting must be adjusted as follows:
Light the oven burner and keep it operating at the highest setting for
10/15 minutes with the door closed. Now turn the knob to the
minimum temperature setting, remove the knob and use a straight-
head screwdriver to adjust.
When using bottled gas, the adjuster screw must be turned fully clockwise. The diameter of the by-
pass is stated in point “5.2 Burner and Nozzle Data Tables”.
If town gas or natural gas is used, it is sufficient to unscrew the by-pass by a few turns. In both cases,
functioning must be tested as follows. Light the oven burner at a temperature of 240°C and leave it on
for 15 minutes. Turn the knob to the minimum temperature setting and adjust the by-pass taking the
flame to a minimum: it should stay lit although the length is 2-3 mm. This operation must be done with
the oven door closed.
After having adjusted the minimum setting try opening and closing the door; if the flame goes out
increase the minimum setting a little. Also, make sure that when changing from the maximum to the
minimum setting the flame does not go out.
5.1.3 Changing the nozzle
Undo the oven burner fixing screws A.
Move the burner B outwards until the nozzle is accessible.
Use a 7 socket wrench to change the nozzle, fitting the one for the type
of gas to be used (see point “5.2 Burner and Nozzle Data Tables”).
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Smeg S-341 GX bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Smeg S-341 GX in de taal/talen: Engels als bijlage per email.

De handleiding is 1,04 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Smeg S-341 GX

Smeg S-341 GX Gebruiksaanwijzing - Nederlands - 14 pagina's

Smeg S-341 GX Gebruiksaanwijzing - Deutsch - 14 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info