21
To increase the number of hours the machine
stays on (max. 3), proceed as follows:
• Press the MENU button (B6) then press the
NEXT button (B7) repeatedly until the ap-
pliance displays: "OFF AFTER 1 HOUR".
• Press the CHANGE button (B8) to change the
number of hours the appliance remains on.
• Press the OK button (B9) to confirm.
• Press the MENU button to exit programming
mode or NEXT to change other parameters.
Setting water hardness
The descale message is displayed after the ap-
pliance has been operated for a factory set pe-
riod of time calculated on the basis of the
maximum quantity of limescale which may be
contained in the water used.
The operating period can be extended if required,
making descaling less frequent by programming
the machine on the basis of the real lime content
in the water used.
Proceed as follows:
• Remove the "Total Hardness Test" strip (atta-
ched to page 2) from its packaging then dip
it fully in the water for a few seconds,
Then remove and wait about 30 seconds
(until it changes colour and forms red squa-
res).
• Switch the machine on by turning the knob
(A7) (fig. 5).
• Press the MENU button (B6) then press the
NEXT button (B7) repeatedly until the ap-
pliance displays "WATER HARDNESS 4".
• Press the CHANGE button repeatedly until
the number coincides with the number of red
squares on the test strip (for example, if there
are 3 red squares on the test strip, press the
button until "WATER HARDNESS 3" is displa-
yed).
• Press the OK button (B9) to confirm.
The coffee maker is now programmed to pro-
vide the descale warning when necessary
based on the actual hardness of the water.
Resetting default values (reset)
If you change the original values, the default va-
lues can be reset as follows:
• Press the MENU button (B6) then press the
NEXT button (B7) repeatedly until the ap-
pliance displays RESET TO DEFAULT NO.
• Press the CHANGE button (B8) and the ap-
pliance displays "RESET TO DEFAULT YES".
• Press the OK button (B9) to reset the default
values.
• The appliance is now reset to the default set-
tings and the "READY" message is displayed.
CHANGING THE LANGUAGE
To change the language, press the CHANGE but-
ton for at least 5 seconds until the appliance di-
splays the installation message in various
languages.
Select the required language as described in the
section "Using the appliance for the first time".
TURNING THE APPLIANCE
OFF
Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be inter-
rupted.
Danger of burns!
During rinsing, a little
hot water flows from the coffee spouts. Avoid
contact with splashes of water.
To turn the appliance off, turn the ON/OFF/stand-
by knob (A7). The appliance performs the rinse
cycle then goes off.
NB!
If the appliance is not used for an
Table of water hardness levels
level German French
degrees degrees
1 = soft 0-6 dH 0-11 fH
2 = soft/medium 7-13 dH 12-23 fH
3=
medium/hard
14-20 dH 24-36 fH
4 = hard > 21 dH > 37 fH
